Quote:
Originally Posted by whn
yes I know but in trying to figure out that is it even possible to do it way I told.
I mean when using the when using new 2.0 version of JB3 which has auto map switching based on flow.
So I ask you guys again the same:
When meth is switched off and I've JB3 normally on map 3 and map 7 is the meth map. How I can be sure that JB3 won't switch to meth map (map 7) when meth is switched off?
|
This has to do with the way the map switch is setup. The failsafe systems are setup to output 12V only when the flow reaches a set window. What that means is the JB3 or Procede sees the 12V signal from the failsafe and changes maps. That also means at 0V, it defaults to the set pump map. Remember even if the system completely failed it would output 0V, so there is really no way you could get stuck in the methanol map. Actually if anything went catastrophically wrong then you would be stuck in the pump map.