I just did the exact steps last night, and successfully removed my JB4. Unfortunately, i am not a handy man and it still took me about 2 hours to complete. However, i am so glad that I found the "USB" method to allow me to unplug those connectors
If anyone else is fighting with those connectors, basically stick an usb to keep the tab disengaged and pull them out - BINGO!!
Quote:
Originally Posted by trixdout
Disconnect battery negative terminal. Begin unplugging all connector clips and plug the stock harness back into sensors. Canbus wires need to be heat gunned if you managed to put those glue wire covers back on. Once all connectors are plugged into each sensor correctly and nothing is loose, plug negative battery terminal back in and you are good to go. Just removed my jb4 the other day with ill effects doing it this way.
|