Quote:
Originally Posted by ksfrogman
You adjust the position of the tail light before you tighten the nuts. The bumper is also adjustable.
|
I did this. The problem is not that it is too high or low needing adjustment.
The problem is that the bottom of the tail light is not flush with the body of the car like the original was. The right side is much more flush.
When looking at the tail light from inside the trunk, the base of all three threads is touching the body of the car, so there doesn't seem to be any more space for the bottom of the tail light to push in further to be more flush with the body.
Could this be a defective tail light?
I'm going to take another look at it and possibly post a pic or two today if the problem is really noticeable.
P.S. Should this be in it's own thread or is it OK to be part of the DIY?