Quote:
Originally Posted by maui86
procede rev2 pnp with CANbus update. i thought about that, but i followed the directions to the T. i can switch maps(engine light blinks 1 or 2)...read codes, clear them etc... i've had no problems up till now...
i did take my car in for the rear brake squeak and they replaced the pads supposedly. then the light for the service interval came on and they forgot to do that service and to schedule another appointment. just been too lazy, maybe my front brake pads are getting low or something? just thought about it now...its coming up to 23k miles and i do a decent amount of spirited driving :-)
teri
|
if i were you I would take out the procede, clear the code and see if it comes back. If it does, take it to the dealer, if it doesn't, the problem is either with the procede or your install.