I just upgraded from a V2 to a V3 (because my V2 screen shat itself!) and since loading the V3, I get a yellow check engine light on startup and code: P2A18 - DMTL diagnosis module tank leakage, heating: input signal.
I was running a PTF map prior, however since my AP serial numbers don't match, I had to flash the 2+ agg map instead. The code didn't show prior to loading the V3.
Any thoughts?
Also, COBB: With unit measurements on the V3, is there a way to set temps as Celsius and boost at PSI?
Thanks!
|