Quote:
Originally Posted by kaigoss69
Why? You will need a line output converter anyway to convert the high level output of the L7 amp to low level. Get an LOC with signal sensing capabilities which will provide you with a turn-on signal for the JL amp.
Edit: Or just use the amp's built-in signal sensing circuit  (but you will still need an LOC) Also, that's a LOT of power for the SWS!!! If you're not careful, you may end up blowing them. |
Yea I'm not worried about the install itself...I'm more worried about wiring the amp and LOC. All my components should be here by this Thursday. So I have some time to research. And yea the JL is pretty beefy. All the gains will be at minimum levels when I start her up though so I think I'll be good. I posted a thread about settings for the JL 500/1 but noone has responded yet.
