Aman, you are the man! Followed this & after 15 minutes, all fixed saving me $600 as no doubt the techs would have replaced both motor & resistor/controller. I googled how to remove the microfilter & found a Utube clip & it was simple -six 6 mm bolts.
Quote:
Originally Posted by aman475
Hello all
I had a problem with the heater blower motor it was not working at all. I checked the fuses ,they were ok then i decided to replace it.but before you replace it please take out the micro filter from under the bonnet
Then from the passenger side duct on the right hand driven cars look at the blower motor .you will see a rusty bolt please take wd40 and a long straw and put it on top of put lot of it eg a spoon full.
Then turn your car on and make sure the blower is on from the digital controls .move the blower motor with help of a screw driver or any other object that could get into the duct .and it will start working .if your motor is not fully blown .
Good luck
|