E90Post
 


Lux Angel Eyes
 
BMW 3-Series (E90 E92) Forum > E90 / E92 / E93 3-series Technical Forums > Cosmetic and Lighting Modifications (exterior/interior) > Reversing light issue



Reply
 
Thread Tools Search this Thread
      12-06-2011, 07:46 PM   #1
gte636p
New Member
 
Drives: 328i
Join Date: Dec 2011
Location: right here

Posts: 7
iTrader: (0)

Reversing light issue

I recently installed a reverse camera, got in a hurry, and didn't check the potentials well at all. In the end I had the inner trunk brake light going through the camera and to the reverse lights (basically put reverse 12V bias on the reverse light wire). The car was fine for a little bit, and then I finally got a bulb out warning for the rear reversing light. The bulb is fine. The wire checks continuity from the light plug to the footwell module. The taillight itself rings clear.

So, I have a NCSxpert up and running. The code did clear out, for a brief while, when I erased the error. However, it came back very shortly after. According to the WDS "This lamp circuit remains switched off until there has been a terminal change (terminal 15 -> terminal R -> terminal 15)."

Therein lies my question. How would I go about making this terminal change... and is this even a coding issue?? I would like to know if this is possible before I even attempt to buy a new footwell module.
gte636p is offline  
0
Reply With Quote
Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 11:24 PM.




e90post
Powered by vBulletin® Version 3.7.0
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
1Addicts.com, BIMMERPOST.com, E90Post.com, F30Post.com, M3Post.com, ZPost.com, 5Post.com, 6Post.com, 7Post.com, XBimmers.com logo and trademark are properties of BIMMERPOST