[Teohenwhy]

Anyone know the commands to set your alarm siren to it's loudest settings in DWAS? Thanks in advanced.

[mrjoe]

+1

[mrjoe]

figured it out. write a blank to the man file and upload it to the dwas. it sets it back to factory. you will have to go and recode anything you had on the dwas mod after you change it. alarm is loud as hell now!!!!

[makkan00]

Originally Posted by mrjoe

figured it out. write a blank to the man file and upload it to the dwas. it sets it back to factory. you will have to go and recode anything you had on the dwas mod after you change it. alarm is loud as hell now!!!!

If you use the expert mode and reset the module by bringing it to default settings, it increases the volume to max.

But even on max volume, it is not loud really.

[eddiem74]

Originally Posted by makkan00

If you use the expert mode and reset the module by bringing it to default settings, it increases the volume to max.

But even on max volume, it is not loud really.

I reset DWAS to default which I believe is:

BUZZER_LOW_LEVEL
wert_04
wert_05

BUZZER_HIGH_LEVEL
wert_04
wert_05

If I tried to change the entries to a higher single value e.g. wert_08 and updated the car when I re-read the module it showed multiple entries (something like below from my memory):

BUZZER_LOW_LEVEL
wert_06
wert_07
wert_08

BUZZER_HIGH_LEVEL
wert_06
wert_07
wert_08

So I changed the entries to a lower value e.g. wert_01 and the following entries were updated:

BUZZER_LOW_LEVEL
wert_04
wert_05

BUZZER_HIGH_LEVEL
wert_01
wert_02

In all cases I cannot notice any significant difference (if any at all) in alarm volume? Should I be able too?

Also why is there a LOW and HIGH Level, how does these work together?

[eddiem74]

Originally Posted by eddiem74

I reset DWAS to default which I believe is:

BUZZER_LOW_LEVEL
wert_04
wert_05

BUZZER_HIGH_LEVEL
wert_04
wert_05

If I tried to change the entries to a higher single value e.g. wert_08 and updated the car when I re-read the module it showed multiple entries (something like below from my memory):

BUZZER_LOW_LEVEL
wert_06
wert_07
wert_08

BUZZER_HIGH_LEVEL
wert_06
wert_07
wert_08

So I changed the entries to a lower value e.g. wert_01 and the following entries were updated:

BUZZER_LOW_LEVEL
wert_04
wert_05

BUZZER_HIGH_LEVEL
wert_01
wert_02

In all cases I cannot notice any significant difference (if any at all) in alarm volume? Should I be able too?

Also why is there a LOW and HIGH Level, how does these work together?

Anyone?