|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
335i E92 Coupe base stereo upgrade
|
|
12-28-2014, 04:07 PM | #23 |
Lieutenant General
1988
Rep 13,280
Posts |
Putting in the underseats it pretty easy .
Putting in the under seats(speakers) is pretty easy
,there are only two bolts holding it down . It's actually easier and less involved than doing the doors. Yes you take enclosures out its easy. You want to have the factory connector on your new speakers. You can buy one or use the old one its your call. There are only a few things you have to be careful about. Don't disconnect the under seat connector for the seat with battery connected if you are going to disconnect it at all. If you do it will cause airbag error it can be reset with a coding setup. I didn't disconnect the battery for this . You just need to lean the seats back to get access. And what I mean by that is in this document. http://www.e90post.com/forums/attach...3&d=1329017429 Also you need to be aware if you don't disconnect that battery you most likely will drain the battery some and may have to recharge it. And whatever you do don't close the trunk with the battery dissconnected its and electric trunk lock. Install procedures http://www.e90post.com/forums/showth...ght=door+wires http://www.e90post.com/forums/showthread.php?t=911595 http://www.e90post.com/forums/showpo...9&postcount=19 http://www.e90post.com/forums/showthread.php?t=571803 http://bavariansoundwerks.com/produc...dan_Logic7.pdf http://www.e90post.com/forums/showth...ht=amp+install http://www.bimmerdiy.com/dir/e90 http://www.e90post.com/forums/showth...DIY+door+panel http://www.e90post.com/forums/showthread.php?t=553388 http://bavariansoundwerks.com/produc...dan_Logic7.pdf http://www.e90post.com/forums/showth...hlight=speaker http://bavariansoundwerks.com/produc...dan_Logic7.pdf Recoding the output of the Head Unit to Hi Fi will correct the eq problem if you can find a way to do it. You use to be able to do it with a simple coding setup in the older cars at some point it required a a more complicated setup called and icom head that programs through the most bus connector. If you can't do that the Jl cleanweep is the cheapest way to do de-eq. There are some newer amp/processor combinations that will do the job of both a decent amp and processor combo the mosconi 120.4 Dsp and Helix makes and 8 channel dsp with 55 watts rms per channel but they are not cheap. http://www.e90post.com/forums/showth...ighlight=helix Last edited by ctuna; 12-28-2014 at 05:21 PM.. |
Appreciate
0
|
12-29-2014, 02:36 PM | #25 |
Lieutenant
94
Rep 448
Posts |
wallysboy, if you have the base system you will need to de-eq the signal before you start adding anything. You can buy speakers and amps, but the signal correction is needed for any aftermarket speakers to sound good. You will also either need to pry the 6.5" underseats out of their current enclosures, or buy Hifi underseat enclosures, which are 8" and the woofer is screwed in. Look into the Alpine DSP with the head unit controller, this unit is sold at Crutchfield and although it will require a fair amount of tuning, it has been used by others in E90/E92 BMW's with no mention of noise/hiss. It is rather expensive, but the other amp/DSP combos are also not cheap, Mosconi 120.4 DSP is close to $1000 new. I'm in the same boat as you, each pay period I am trying to buy more pieces to complete the puzzle, hopefully everything of mine will go in this spring.
|
Appreciate
0
|
12-29-2014, 06:26 PM | #26 |
Private
13
Rep 50
Posts |
OzCo- Thanks for the info and suggestions. It is always nice to hear what others have done in similar situations. After spending $$$ for go-fast performance upgrades, the money is a bit tight. I thought I hit the jackpot with a combo De-EQ/Amp for $300 but of course it was too good to be true One step at a time for now.
|
Appreciate
0
|
12-29-2014, 10:32 PM | #27 |
Lieutenant Colonel
193
Rep 1,677
Posts |
I'm now using the Fiio E-17 Alpen again. Turns out the static I was getting was from having the volume programmed to be too high in the AirEnabler.
I tried the Audioquest Dragonfly when I thought the Fiio was defective (which it wasn't) and it sounded good, too, but could not get the sound level to come close to matching the other sources (CD, SAT, FM). Plus, the Dragonfly was getting pretty warm. I talked to Audioquest about the use of the Dragonfly in this situation and they said they had never heard of Airplay for the car and did not support the use of their product for this application. I worked with Qui (from AirEnabler) and we tried some new settings for the Dragonfly but they never worked out very well. So...I went back to the Fiio, reduced the volume of the AirEnabler from 95 to 85 and bumped up the volume on the Fiio to 58 out of 60 and it sounds great. I see no reason to use anything else at this point. Plus the Fiio can be used as a portable head phone amp. http://www.amazon.com/E17-Alpen-Port...&keywords=fiio
__________________
2008 Montego "330i" /3.0 manifold /AA /Eurobox /PE /Alufelgen CS7 /Macht Schnell /Michelin PSS /XPel
"O thou afflicted, tossed with tempest, and not comforted, behold, I will lay thy stones with fair colours, and lay thy foundations with sapphires." (Isaiah 54:11) |
Appreciate
0
|
12-30-2014, 12:10 AM | #28 | |
Private
4
Rep 95
Posts |
Quote:
|
|
Appreciate
0
|
12-30-2014, 05:43 PM | #29 | |
Private
13
Rep 50
Posts |
Quote:
|
|
Appreciate
0
|
12-30-2014, 06:01 PM | #30 |
Lieutenant General
1988
Rep 13,280
Posts |
Don't know exacltly but it still might require some coding
Don't know exactly but it still might require some coding to get whatever
options you have to play. Like SOS and PDC if you have it. There is thing called the VO Code that determines what is enabled according to the options list. This is what is in my radio file for example and I have Hi Fi with SOS and bluetooth phone. This is an 06 wagon with Hi Fi . CODIERUNG_ERFOLGT codierung_erfolgt CDC nicht_aktiv AUDIO_SYSTEM pl2_hifi pl3_hifi SDARS nicht_aktiv PDC nicht_aktiv ACC nicht_aktiv STANDHEIZUNG nicht_aktiv AUX_RAD aux BAUREIHEX e9x COUNTRYCODE_RADIO us IBOC nicht_aktiv KEY_MEMORY_R aktiv MUTE_TIMES pl2 NACHLAUF_INT_R pl2 RIGHTHAND nicht_aktiv SOFTEN_ENTERTAINMENT_PDC nicht_aktiv TCU_ECE nicht_aktiv TIMEOUT_INT_R pl2 ULF_ECE nicht_aktiv BMW_AKD nicht_aktiv BMW_HOME_DEALER aktiv BMW_INITIALIZE aktiv BMW_MOBILE_SERVICE aktiv BMW_PHONE_SERVICES nicht_aktiv BMW_ROAMING nicht_aktiv BMW_TELESERVICE_ONLY nicht_aktiv RING_STATUS aktiv BLUETOOTH_RAD2 aktiv DISPLAY_LOGIC7 nicht_aktiv HI_TEMP_VOL_CTRL pl2_hifi pl3_hifi SMS_RAD2 nicht_aktiv PHONE_BUSINESS_R2 nicht_aktiv SVS_LOW_RAD2 aktiv BMW_ASSIST_RAD2 aktiv BMW_HOTLINE_RAD2 aktiv DAB nicht_aktiv CAR_COMP_ACTIVE aktiv TCU_JAP nicht_aktiv CONTACT_NR_DEALER aktiv CONTACT_NR_HOTLINE aktiv CONTACT_NR_MOBILE_SRVC aktiv ABS_VOL_GONG e91_hifi CROSSOVER pl2_hifi e90_hifi r56_stereo r56_hifi DELTA_GONG_ENT wert_0 DELTA_PDC_ENT wert_0 RATIO_AUDIO_SOURCES ece us VEHICLE_FILTERS e81_stereo e82_stereo e87_stereo e88_stereo e90_stereo e91_stereo e92_stereo e93_stereo pl2_hifi r56_hifi VOL_TEL_MAX stereo_mulf_e87 hifi_mulf_e87 top_hifi_mulf_e87 stereo_mulf_e90 hifi_mulf_e90 top_hifi_mulf_e90 stereo_mulf_e91 hifi_mulf_e91 top_hifi_mulf_e91 stereo_tcu hifi_tcu top_hifi_tcu VOL_TEL_MIN wert_0 VOLUME_TABLE e91_hifi MY_INFO_RAD2 nicht_aktiv V_INFO_RAD2 nicht_aktiv PHONE_PROF_RAD2 aktiv There is a Euro Head Unit that looks like the pro head unit now that has Hd Radio , USB and bluetooth phone built in now but it requires some tricky programming to get it to play with and old car. I think I would try to get the existing one programmedto Hi Fi first. I think the base stereo does require the icom head to get it to reprogram though. I would see if I could find coder in your area that would do it. You need to go to the coding subforum to find one. Also Taibanl had this done I think. And Makan00 is an expert on this subject. I believe he said radio 08 and afterward need the icom head to reprogram them to Hi Fi . If you have a car or radio older than that it can be programmed with a simple coding cable. Last edited by ctuna; 12-30-2014 at 10:42 PM.. |
Appreciate
0
|
Bookmarks |
|
|