|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Limp mode with out symbol!!!?? help
|
|
12-01-2008, 09:03 PM | #1 |
Lieutenant
27
Rep 569
Posts |
Limp mode with out symbol!!!?? help
So I gave the car a little gas and a pop sound happened and then all the power was gone... Like a limp mode... But nothing on the dash lit up... I just put on the riss racing DDV kit and Im not sure if its a boost leak that caused this but there is no boost what so ever and there is no symbols on the dash... Any ideas out there?
__________________
N55
|
12-01-2008, 09:06 PM | #2 | |
441
Rep 18,331
Posts |
Quote:
|
|
Appreciate
0
|
12-01-2008, 09:16 PM | #8 |
274
Rep 6,510
Posts |
|
Appreciate
0
|
12-01-2008, 09:22 PM | #9 |
441
Rep 18,331
Posts |
What is the advantage of Riss setup and their DV compared to OEM and forge DVs...In my opinion I think the OEM connection of the charge pipe is much better than the clamps because of all the oil residue will eventually make those clamps slippery and eventually slide off the charge pipe..
|
Appreciate
0
|
12-01-2008, 10:48 PM | #10 |
Major General
153
Rep 5,780
Posts |
As I recall, the OP has the V3. If so, that should prevent overboost codes in the DME by tripping to valet mode. If the current maps are used, a error code would have been recordeed there until the ignition was switched. But that may explain why the DME didn't set a code.
|
Appreciate
0
|
12-01-2008, 11:26 PM | #11 |
Major General
248
Rep 6,125
Posts |
If you guys don't mind me asking very very stupid question, could you tell me what exactly "limp mode" means?
After I GBed JB3, I'm reading a lot of piggy back mods and I hear a lot of "limp mode" from there. Please be generous and teach me what it is. Thanks in advance.
__________________
PAST: F80 M3 ZCP | 911.1 C2S | F10 M5 ZCP | E70 X5M | E90 M3 | E46 M3 | E36 M3 |
Appreciate
0
|
12-01-2008, 11:47 PM | #12 |
Lieutenant
27
Rep 569
Posts |
well hers what happened.... One of the clamps they included is too big... therefor it wont clamp down tight enough of the throttle body! I would expect more from Riss Racing... The 3 other clamps are the right size but the one on the throttle body side is too big... Now I have to go pick up a smaller clamp...
__________________
N55
|
Appreciate
0
|
Bookmarks |
|
|