Disable Light System Failure?

vexvi · 02-12-2013, 02:07 PM

Hello all,

After i installed my HID system. I got two warnings on my display.

1. low beam error
2. red Car on jack (CC-ID 231 Light System Failure)

I was able to disable the warning message for the low beam error and it fix that issue

But i can not correct the second warning light. If i go to the service section (basically the place you can reset your oil and so on), it shows that everything is good.

any ideas??

rich123321 · 02-12-2013, 07:36 PM

Quote:

Originally Posted by vexvi

Not sure but can it be my FRM?

You have to code the correct voltages I believe

vexvi · 02-13-2013, 12:26 AM

thanks for the reply! i was able to solve the issue

cn555ic · 02-13-2013, 06:24 AM

Well for those that have the same issue, Posting your were able to solve it is great and all, but you should post how you fix it and what u did.

vexvi · 02-13-2013, 05:20 PM

absolutely! Updated this post. I have narrowed the issue to being one of my HID's. not sure if its the ballast that caused that error but i will update my findings

02-12-2013, 02:07 PM	#1
vexvi New Member 3 Rep 25 Posts Drives: 2006 325i Join Date: Jul 2009 Location: Ohio iTrader: (0)	Disable Light System Failure? Hello all, After i installed my HID system. I got two warnings on my display. 1. low beam error 2. red Car on jack (CC-ID 231 Light System Failure) I was able to disable the warning message for the low beam error and it fix that issue But i can not correct the second warning light. If i go to the service section (basically the place you can reset your oil and so on), it shows that everything is good. any ideas??
	Appreciate 0 Tweet Quote

02-13-2013, 12:26 AM	#3
vexvi New Member 3 Rep 25 Posts Drives: 2006 325i Join Date: Jul 2009 Location: Ohio iTrader: (0)	thanks for the reply! i was able to solve the issue Last edited by vexvi; 02-13-2013 at 05:22 PM..
	Appreciate 0 Quote

02-13-2013, 06:24 AM	#4
cn555ic 441 Rep 18,331 Posts Drives: 335i Join Date: Jun 2007 Location: US iTrader: (6)	Well for those that have the same issue, Posting your were able to solve it is great and all, but you should post how you fix it and what u did.
	Appreciate 0 Quote

02-13-2013, 05:20 PM	#5
vexvi New Member 3 Rep 25 Posts Drives: 2006 325i Join Date: Jul 2009 Location: Ohio iTrader: (0)	absolutely! Updated this post. I have narrowed the issue to being one of my HID's. not sure if its the ballast that caused that error but i will update my findings Last edited by vexvi; 02-14-2013 at 03:51 PM..
	Appreciate 0 Quote