|
|
|
|
PLEASE HELP SUPPORT E90POST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
|
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
|
BMW 3-Series (E90 E92) Forum
>
Wheel Fit Question
|
|
Wheels and Tires forum Sponsored by The Tire Rack
Please help to directly support e90post by doing your tirerack shopping from the above link. For every sale made through the link, e90post gets sponsor support to keep the site alive. Disclaimer |
|
Thread Tools | Search this Thread |
02-18-2011, 04:31 PM | #1 |
Private
10
Rep 73
Posts |
Wheel Fit Question
Hey all:
Im looking to pick up a set of 19" wheels and was wondering if they will rub after I drop the car 1". Will I need to roll the fenders or need spacers? Thanks The rims are 19" by 9.0 with 40mm offset was thinking about running 235/35/19 front and 255/30/19 rear |
02-18-2011, 04:40 PM | #2 |
Brigadier General
406
Rep 3,879
Posts |
you wont rub at all, you need a 5mm spacer up front i clear the suspension I think. You will want spacers int he rear too, around a 10mm. an ET40 is very conservative
|
Appreciate
0
|
02-18-2011, 08:53 PM | #3 |
BimmerPost Supporting Vendor
2038
Rep 25,989
Posts |
Front and rears will be perfectly fine. 235/255 are good sizes. You can throw about another 10-12mm spacer in the rear if you would like.
-Charles@VMRWheels
__________________
VMR|Wheels | 714.442.7916 |
sales@velocitymotoring.com | www.velocitymotoring.com | facebook | flickr | Instagram |
Appreciate
0
|
02-19-2011, 02:42 PM | #4 |
Ex-Diesel Driver
62
Rep 2,000
Posts |
You could go to 265... why not go wide?
__________________
FS: HRE Center Caps http://www.e90post.com/forums/showth...post13972317l] |
Appreciate
0
|
05-31-2011, 04:57 PM | #5 |
Private
10
Rep 73
Posts |
Wheel fit question
OK so im going to keep my sport suspension on my E92 and I have the drop perches in the front now. If I run a 265 in the rear with the 40mm offset and a 10mm spacer will the clearance be ok?
Thanks |
Appreciate
0
|
Bookmarks |
Thread Tools | Search this Thread |
|
|