|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Possible to run MHD flash only with JB4 installed?
|
|
09-01-2019, 01:01 PM | #1 |
Captain
347
Rep 801
Posts |
Possible to run MHD flash only with JB4 installed?
Is it possible to run MHD stage 2+ flash only with the JB4 installed? I’m just looking to compare the drivability of the MHD only compared to JB4 + BEF. Do I just set the JB4 to map zero and run the JB4 in flash only mode?
Thanks. |
09-02-2019, 12:32 PM | #5 |
Banned
550
Rep 949
Posts |
|
Appreciate
0
|
09-02-2019, 12:57 PM | #6 | |
Captain
347
Rep 801
Posts |
Quote:
Do you plug the white connectors for the JB4 back into themselves or leave them disconnected? Is there any information listed anywhere on how to use it as a meth controller only while running full flash only? I’m a bit confused as to how to do it. Thanks. Last edited by HKD126; 09-02-2019 at 03:07 PM.. |
|
Appreciate
0
|
09-02-2019, 06:00 PM | #7 |
Banned
550
Rep 949
Posts |
White subconnector just sits out of the way. On mode 4/4 with no white subconnector the you'd just select map1, and set meth trigger = 1 to enable meth flow. That is the most basic implementation.
|
Appreciate
0
|
Bookmarks |
|
|