[hardr85]

After you change the VO in the CAS and FRM(e90), I have read that you have to code the entire car for the changes to take effect, is this required? If so, can someone post the steps to complete?

If you can, start the steps immediately after writing the FA to the last module.

Thanks in advance

[B3NPM]

Originally Posted by hardr85

After you change the VO in the CAS and FRM(e90), I have read that you have to code the entire car for the changes to take effect, is this required? If so, can someone post the steps to complete?

If you can, start the steps immediately after writing the FA to the last module.

Thanks in advance

You do not need to code the whole car.

Simply default code (Using blank .MAN file in "revtor's" profile OR just use "Expertmode" profile) the CAS and FRM modules individually. One at a time, set "SG_CODIEREN" as the job and then "execute job"

You may then want to default code the module you have just installed in the case of a retrofit or replacement. Depends on what your adding or removing from the VO

[Samak89]

Hey ,

Do you still have this pdf file ? It doesn’t seem to load and I’m getting an error.