|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Can Procede Installed Cause This?
|
|
12-02-2011, 08:57 AM | #1 |
Lieutenant
45
Rep 437
Posts |
Can Procede Installed Cause This?
I went to get my car inspected and I failed due to:
Catalyst: Not Ready Evap: Not ready O2 Sens: Not ready O2 Sens Htr: Not ready I have no codes thrown and car seems to drive fine. Any ideas? Picture attached |
12-02-2011, 09:10 AM | #2 |
Lieutenant Colonel
29
Rep 1,551
Posts |
Yes. The procede supresses the dash light caused my cat-uncreadyness. You have to undo the harness mod to trick the ecu into thinking the cats are still there. This can take a few driving cycles and you increase/decrease the voltage to within spec. This is assuming you haver a newer or harness-modded older unit.
|
Appreciate
0
|
12-02-2011, 09:21 AM | #3 | |
Lieutenant
45
Rep 437
Posts |
Quote:
|
|
Appreciate
0
|
12-02-2011, 09:26 AM | #4 |
Captain
16
Rep 639
Posts |
Turn canbus off and go drive around for a bit. Then you'll be good.
__________________
07 e92 335i | BSM | SB | Gray Poplar Wood Trim | 6MT | Premium | Sport | Cold Weather | iDrive | Logic7 | Comfort Access |
|
Appreciate
0
|
12-02-2011, 09:29 AM | #5 |
Lieutenant Colonel
65
Rep 1,708
Posts |
|
Appreciate
0
|
12-02-2011, 09:32 AM | #6 |
Captain
16
Rep 639
Posts |
Oops I meant to say can clear. Lol
__________________
07 e92 335i | BSM | SB | Gray Poplar Wood Trim | 6MT | Premium | Sport | Cold Weather | iDrive | Logic7 | Comfort Access |
|
Appreciate
0
|
12-02-2011, 10:01 AM | #8 |
Formerly (-(ellblazer420
48
Rep 703
Posts
Drives: 07 E90 335i M/T, 15 F80 M3 DCT
Join Date: Sep 2010
Location: SF East Bay, CA
|
Canclear is used to clear O2 sensor codes. (hence why catalyst and EVAP are not ready) Since you still have your stock cats you have nothing to worry about. Just turn off canclear and drive for a while. It will allow your monitors to set a ready status for your catalyst and your EVAP. You then take the car back in for smog once the monitors are all set. After smog you can just turn canclear back on. Nothing to worry about very standard when smogging the car with the procede installed.
|
Appreciate
0
|
12-02-2011, 11:04 AM | #9 | |
Major General
422
Rep 8,004
Posts
Drives: '08 E90 335i, '99 E36 M3
Join Date: Apr 2009
Location: Houston, TX & Atlanta, GA
|
Quoting myself here...
Quote:
|
|
Appreciate
0
|
12-02-2011, 11:18 AM | #10 |
Lieutenant
45
Rep 437
Posts |
thank you all for the help...my laptop got stolen so I guess this is a good time for me to uninstall procede and send it in for 2.5 upgrade while I get my car inspected...thanks!
|
Appreciate
0
|
Bookmarks |
|
|