[Paris75]

hello

(sorry for my English)

I have installed ista 4.19, it works perfectly with windows 10.
but I have not tested it on my car ( Enet Cable X3 F25).

The doubt I have, is :
my hard disk C: is full ! I installed on my second internal hard disk D: ista and ediabas.

as I wrote above ista works normally on windows 10, is this, when I will connect to the vehicle, everything will work ?

No worries with ediabas installed under D: ?

thank you

[Tambohamilton]

Ista and ediabas have no issues coexisting on the same drive

[Paris75]

Thank you very much.

As mentioned above, I use an ENET cable, ista works under windows.
What is the use of BLP (1go) and SDP (128Go) ?
I decompress them in Rheingold ?
it seems that it is necessary for ista ?

[Tambohamilton]

I'm not sure. I don't understand where all the files need to go, etc. I think SDP must be all the daten files, though I can't remember exactly what they're needed for either.

[Paris75]

I found the answer!
I use an enet cable, I don't need BLP and SDP.

ISTA+ PROGRAMMING WITH E-NET OR D-CAN INTERFACE WILL NOT WORK! ICOM IS REQUIRED!
IF YOU DON’T HAVE ICOM INTERFACE, FILES(SDP and BLP) ARE USELESS FOR YOU!

------->
https://diagnose-software.myshopify....on-instruction