|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
BMS CAN TOOL not working?
|
|
07-14-2013, 03:27 PM | #1 |
First Lieutenant
47
Rep 385
Posts |
BMS CAN TOOL not working?
I have the BMS CAN Tool and have never used it before but bought it to clear codes (if any) from my burger tuning stage 1 tune for a 2012 F30 335.
I plug in the cable into the car and push the single button on the CAN TOOL and nothing happens? I read this and expected the speedo and blinkers to come on and give me signals so I could use the tool but nothing happens. http://burgertuning.com/instructions/CANtool.pdf Shouldn't it be doing this? http://youtu.be/CffWwSLOflw Please help as I have a dealer appointment tomorrow morning and may try and cancel if I can't be sure codes have cleared tonight. Thank you. |
07-14-2013, 05:07 PM | #2 |
First Lieutenant
47
Rep 385
Posts |
Answer received from Terry at burger on a Sunday afternoon! Great service.
Short answer is on F30 there is no dash feedback. You just plug it in and push button and leave it for a few minutes. Also my green light on the inside of the tool was blinking not solid and he said that is normal. |
Appreciate
0
|
Bookmarks |
|
|