[ctuna]

I saw that on the 5 series board
But the guy came back and said he still had the error
if I read the thread right.

http://forums.5series.net/bluetooth-...-111053/page2/

[carlosalbertogui]

Originally Posted by dylim

I have both MULF high is used for the USB, and TCU takes over the phone/BT functions.

I just looked at my notes. To code out the SOS check, just use NCSEXPERT, connect to TCUM, and change E_CALL_HARDKEY_FITTED to nicht_aktiv.

can you explaine in detail how to use ncsexpert ,.... i will buy the cable and start to recode

best regards

[ctuna]

You need to go to the coding board and study the stickys

http://www.e90post.com/forums/forumdisplay.php?f=368

Don't do anything till you are sure of what you are doing.

[carlosalbertogui]

hi all

cannot read Tcum module throws an error

what to do next ???

[Najt]

ou yeah. Finally. I've removed the BMW Assist code $612 but the SOS failure was still annoying on iDrive after engine started. So i've tried to add +TELD to VO, recode TCUM with default settings..and tadaaaaa the warning is gone

thanks God



//edit:
@carlosalbertogui: I had the same problem. I think I had to change something in Ediabas setting.or I can sent you my ncs expert and ediabas and inpa , maybe it will work

[vitez180]

Originally Posted by snoozee

removing $639 from the VO list will remove the BMW assist feature and should get rid of the error.

someone mentioned that the below steps solved his problem.

Do you have to do a Coderdaten_Lesen first on each module before writing or you can just FA_write right after you change it.