|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Factory Speaker Wire
|
|
06-08-2018, 04:58 PM | #1 |
Private
4
Rep 98
Posts |
Factory Speaker Wire
I recall reading on the forum that the factory speaker wire is good up to 150 watts, taken that into account could I tap three speakers in the factory speaker wire and then out through the harness.
Hope that makes sense >>> 4" components, 2 x 6.5" mid's |
06-08-2018, 06:50 PM | #2 |
Lieutenant General
1911
Rep 13,103
Posts |
The number is correct what you are trying to do is not clear.
Remember if you wire speaker in parallel is increases the load on the amp it shouldn't go below 2 ohms a 2 ohm stable amp. Last edited by ctuna; 06-09-2018 at 10:53 PM.. |
Appreciate
0
|
06-08-2018, 06:52 PM | #3 |
Lieutenant General
1911
Rep 13,103
Posts |
The number is correct what you are trying to do is not clear.
Remember if you wire speaker in parallel is increases the load on the map it shouldn't go below 2 ohms a 2 ohm stable amp. If you are trying to attach all those speaker to a factory amp the amp is probably not going to cut it. |
Appreciate
0
|
06-09-2018, 03:38 AM | #4 | |
Private
4
Rep 98
Posts |
Quote:
I'm trying to figure out, what is going to be the easiest for me to wire up the door pods to a separate amp. Rather than running new wires, I'm hoping I can tap in the factory wires again as I did for the components. |
|
Appreciate
0
|
06-09-2018, 03:46 AM | #5 | |
Banned
15
Rep 50
Posts |
Quote:
|
|
Appreciate
0
|
Bookmarks |
|
|