|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Proceed Meth install PART LEFT OVER
|
|
11-17-2012, 12:16 PM | #1 |
Oldie Newbie
4
Rep 134
Posts |
Proceed Meth install PART LEFT OVER
Shop took this out when installing proceed meth kit. Anyone know what it is? If I need it? Has an FCC sticker and blue wire looks like antennae
__________________
2007 335 coupe, M3 suspension, Koni Yellows, Ground Control camber plates, RB rotors, Kosei K-1 17" with 255 x 40 square Direzzas or BFG R1
Last edited by BRO; 11-17-2012 at 01:15 PM.. |
11-17-2012, 05:25 PM | #2 |
Brigadier General
133
Rep 4,764
Posts |
Original Vishnu PPS Meth kit used remote control to arm the system. Most of us ditched that part of it and hardwired a switch in the cabin instead. That looks like the remote box with the antenna.
|
Appreciate
0
|
11-17-2012, 05:31 PM | #3 |
441
Rep 18,331
Posts |
That is indeed the remote control to turn on the old meth kit that Vishnu came out with. Most if not all have ditched that as there was no indicator if it was on or off. Just put it aside as stuff that is junk.
|
Appreciate
0
|
11-17-2012, 11:43 PM | #4 |
Oldie Newbie
4
Rep 134
Posts |
Thanks for the replies. I had to take the car before the firmware was loaded and the operation checked. Today I activated map 4, but no meth flow was indicated by the turn signal flash. Might this be why?
__________________
2007 335 coupe, M3 suspension, Koni Yellows, Ground Control camber plates, RB rotors, Kosei K-1 17" with 255 x 40 square Direzzas or BFG R1
|
Appreciate
0
|
11-18-2012, 08:38 AM | #5 |
Brigadier General
133
Rep 4,764
Posts |
Could be any number of things. It sucks, but you really should do a wiring diagram and post it to make sure it is hooked up right. Here was my chicken scratch diagram of the original vishnu kit hardware without the remote control.
Last edited by scottp999; 11-18-2012 at 08:57 AM.. |
Appreciate
0
|
Bookmarks |
|
|