|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Diy Code P0440 Fuel Ventilation Valve
|
|
04-20-2012, 12:21 AM | #1 |
Banned
83
Rep 466
Posts |
Diy Code P0440 Fuel Ventilation Valve
the process was pretty simple except for locating the fuel vintilation valve. then the next difficult process was removing the last clip on upper rear of throttle body. I actually had to squeeze my left hand through the rear of alternator and right hand with a flat head slowly pushing on the clip to release it. The rest was pretty simple after I located the fuel vintilation valve. part cost $62 the dealer would have charged 400+ to do this. hope you guys like it!!
Last edited by pinoye90; 04-23-2012 at 04:14 PM.. |
04-20-2012, 12:28 AM | #2 |
Banned
83
Rep 466
Posts |
MAKE SURE THE CAR IS COLD BE VERY CAREFUL YOUR WORKING WITH FUEL VAPORS..
1. Remove The Air Box 2. Locate The Fuel vintilation Valve (bottom Of Throttle Body) 3. First Unclip Lower 2 Clips A. Rear Push On Pin Then Pull B. Squeeze, Pull. 4. Slide Out Of Fuel Valve Holder PULLING Towards Front Of Vehicle 5. Remove Upper Clip (3) On Upper Rear Of Throttle Body (squeeze Then Pull) 6. Reverse Steps Ans No More Check Engine Light!!!!!! Last edited by pinoye90; 04-23-2012 at 04:11 PM.. |
Appreciate
0
|
11-17-2012, 01:54 AM | #3 | |
Team iTouge
121
Rep 2,101
Posts |
I have been searching for this answer for so long!! Thank you!! Btw, would this effect emissions if I were to smog my car? Like sniffer test wise not the CEL part?
__________________
Quote:
Last edited by kiwi29; 11-17-2012 at 02:11 AM.. |
|
Appreciate
0
|
04-21-2013, 05:45 AM | #4 |
Captain
38
Rep 823
Posts |
Anyone know if this applies to 330i? Also anyone have part number I cant find it on Realoem for 03/05 production year 330i.
__________________
/// OEM /// |
Appreciate
0
|
Bookmarks |
|
|