[Icekube]

.

[makkan00]

Originally Posted by Mr Singh

Good work Sam!

I assume by the nature of there design the outer halos don't have the same light output as the inner halos?

Thanks Mr Singh
Thats correct. Its the design. They outer rings are visible during the night, but during a sunny day, they are dull and hardly visible.

For both of them to be equally bright, I guess we need Joshs' mod.

[Danny.B.]

Awesome job mate, now im back home im even more motivated to get mine done!

Just need some OEM Ballasts now!!!

[makkan00]

Originally Posted by Danny.B.

Awesome job mate, now im back home im even more motivated to get mine done!

Just need some OEM Ballasts now!!!

Mate, do it as soon as possible. Worth of upgrading it.

[ukbeemerboy]

Car looks spot on with the Xenons fitted. Wait until you drive a car with "normal" headlights again and see how rubbish they are compared to the Xenons!

[makkan00]

Originally Posted by ukbeemerboy

Car looks spot on with the Xenons fitted. Wait until you drive a car with "normal" headlights again and see how rubbish they are compared to the Xenons!

Thanks mate. I see what you mean. With xenons, road is so much brighter.

[makkan00]

Originally Posted by makkan00

Guys
Finally, xenons and washer jets installed on my car.
I need to connect the wiring / fuse / relay for the washer jet at some stage.

At the moment here are the issues:

1- Since LCI headlights are bi-xenon and shutters get connected with the high beam wire. It works when headlights are on. However when xenons are off, high beam triggers the shutter and as there is no xenon, therefore nothing happens.

Any suggestions for the solution?
If no, then I guess I will have to install the rest of the wiring and level sensors.

Finally cracked it. I can confirm that my high beam is working as it should work in bi-xenon fitted car (even without the low beam on). I did not add OEM wiring but used a hack and coding to work it out.

All good!

If time allows, I will write a DIY and put it in DIY section.