|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
extra wiring help, and pivot gauges not working
|
|
03-27-2012, 06:25 PM | #1 |
New Member
11
Rep 28
Posts |
extra wiring help, and pivot gauges not working
I found some extra wires in my engine bay and was wondering if anyone knows what they were originally ran for? also I have a 3 pod pivot gauge setup they are getting power but they are not getting any info, they are electronic gauges that run off the OBDII I followed the schematic and everything seems to be in order. except it has a stand alone power wire ran to the fuse box, the schematic doesnt have this. I disconnected it and only ran it to the OBDII, same result got power but no information. I provided some photos of the wires and pivot gauge schematic.
By drwharton85 at 2012-03-27 By drwharton85 at 2012-03-27 By drwharton85 at 2012-03-27 By drwharton85 at 2012-03-27 By drwharton85 at 2012-03-27 By drwharton85 at 2012-03-27 |
03-27-2012, 07:48 PM | #2 |
Major General
688
Rep 6,845
Posts
Drives: 2018 Audi RS5 coupe
Join Date: Jul 2008
Location: Reston, VA
|
The wires in the top 4 pics are a left over install of the camaros hid angel eye kit
__________________
|
Appreciate
0
|
03-28-2012, 10:43 PM | #3 |
Mr. Nice Says Hello
636
Rep 16,662
Posts
Drives: BMW M3 | X5 xdrive 35i MSport
Join Date: Dec 2008
Location: USA
|
Yes the wires are from the camaross kit. The ballast blew and upon the request of the guy who bought the car I took them out. Also to get the gauges working the pins in the obd2 port needs to be modified.
You will need to move the pin. I never got around to modifying it. Just make it look like the correct connector and should work |
Appreciate
0
|
Bookmarks |
|
|