|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Help! Window error appears after removing battery!
|
|
05-30-2010, 09:04 AM | #1 |
Enlisted Member
23
Rep 39
Posts |
Help! Window error appears after removing battery!
I removed my battery, then after plugging it i got this "error" of a window with a exclamation mark on its side, i looked it up in the manual it says
"Trap protection of window lifts faulty" but the windows are working perfectly, up and down, its just this error lamp! Did this happen to anyone before? or does anyone know how to disable it? Here is the pic
__________________
|
05-30-2010, 06:57 PM | #2 |
Banned
173
Rep 3,415
Posts |
Try this:
An initialization must be performed: • In the event of malfunctions, e.g. no one-touch control function, no opening or if available no comfort function is possible • After the power window drive has been replaced • After work is carried out on the power window mechanism • If necessary, after an open circuit, e.g. disconnection of the battery or disconnection of the power supply to the door • After the door window glass has been removed and installed or replaced • After adjustment work on the door window glass • After adjustment work on the convertible top • After replacement of seals Initialization is performed on the power window switch of the relevant door. Requirements for correct initialization: • Terminal "R" activated • Doors and windows closed • Sufficient battery voltage; connect charger if necessary Initialization comprises: • Erasure of initialization • Reinitialization Erasure of initialization: • Open door window glass fully • Actuate power window switch in "Open" position (second switch position) and hold down for between 15 and 20 seconds This clears initialization of the power window. Anti-trapping protection and one-touch control (toll) function are inactive. Check whether one-touch control (toll) function is inactive, otherwise repeat procedure. Reinitialization: • Close door window completely • After upper end position is reached, interrupt actuation of power window switch and then hold switch again for approx. 1 second in "Close" position (second switch position) • Open door window glass fully • After upper end position is reached, interrupt actuation of power window switch and then hold switch again for approx. 1 second in "Open" position (second switch position) • Close door window completely • After upper end position is reached, interrupt actuation of power window switch and then hold switch again for approx. 1 second in "Close" position (second switch position) This completes initialization. Note: Carry out function check (one-touch control function, anti-trapping protection and, if necessary, comfort function). Note: The power window can also be initialized in the BMW diagnosis system by means of a diagnosis job. |
Appreciate
0
|
06-03-2010, 09:22 PM | #4 |
Second Lieutenant
7
Rep 220
Posts |
I looked it up on Google and you may need to replace your windows anti-pinch sensor. I don't think that is the correct name for it, but it is the sensor that makes the window go back down if it senses too much resistance when the window is closing.
__________________
"No matter what side of the argument you are on, you always find people on your side you wish were on the other." - Jascha Heifetz
|
Appreciate
0
|
Bookmarks |
|
|