[RIDERDIE]

Already posted this in the general discussion section was told I would get help here.


Sorry for the double post
Thanks

12 codes after Jb4 install NEED advice

--------------------------------------------------------------------------------

Car only has 23k on it, really hoping a connector came loose from me craming the ecu lid back on.

2d1f accelerator pedal module
29e2 charge air temp sensor
2d58 dme
2a9a cam sensor inlet signal
2fbc fuel pressure control valve
0000 ?
0000 ?
2a9b cam sensor exhaust signal
2f0d radiator blind input signal
2901 ?
29d2 misfire
00f1 ?


Anybody have any ideas?
Again since the codes are all over the place im hoping its a loose connector.

Does the fact they all start with 2 suggest its one connector?

Thanks

[WilliamS]

Yup you either swapped a connector or did not seat it properly. Start over, take your time, breath.