[gtabfknkdnme]

So I just put in 6000k low beam bulbs and 6000k hid fogs.

When putting the driver's side in I think i may have unplugged the adaptive headlight connector. It was just there, it seemed like it had been there and not connected to anything. So after I put everything back together I get two warnings, one for a headlight out (which shouldnt happen because Andrey-Onebadmofo said he took off that warning light) and one for adaptive headlight error

1. Does anyone know if the AHL connector is a small rectangular white plug located next to a bluish green square connector, sort of directly under where the low beam bulb plugs into?

2. If this is disconnected, would it cause the passenger side low beam bulb to continuously go out and come back on ever minute or so. OR has anyone that put 6000k bulbs in experienced the passenger side going out for a few seconds or a minute and coming back on?

(if I trouble shoot this and cant come up with anything i'm going to put the passenger side bulb into the driver's side and see if it happens)

Reason I didnt just go back in and try and plug it in was because I'm losing sunlight so I'm going to go in and address it tmro after work

Any is appreciated!!

[gtabfknkdnme]

btw, i also have my angel eyes unplugged, so i dont know if that has anything to do with it

[evoralliart]

Bu,p

[tracerit]

if your angel eye bulb isn't connected you'll get an error. that's all iknow.

[gtabfknkdnme]

the angel eye's error should be coded out.

anyone know if this will cause my passenger side headlight to go out?

will it cause my AHL to have an error?

will it cause my fogs to go out?