[335inYEG]

Just bought a set of vossen cv4's and the tire size is 245/35zr20 front and 285/30zr20 rears.
20x9 + 35
20x10.5 +42

What modifications will need to be done to fit these without any rubbing?


On a 2008 E92 335i

[Aashenfox]

That's a tough one, I don't have much info about 20s on our car. Hopefully MonacoBlue can help with more specific info, but from what I'm reading, you may have to go 235 in front to get the sidewall under the fender. You can't mod front fenders anyway. The front wheel specs sound fine, its just the 245 tire that makes me worry. I expect you'll need a roll in the rear too for 285s. Just guesses, wait for other input before making a decision. I'm running 19x9.5+38 in the back with 275s and while I do have a roll in the rear, I don't think it was 100% necessary, the previous owner did it, looks like it might have 'just' cleared anyway, on the limit.

P.S. You'd have been better off posting this in the wheels and tires section

[335inYEG]

anyone??

when i installed the rear tiresand driving up and down my driveway it would slightly rub on the fabric part of the wheel well, plan is to install a spacer and roll the rear quarters to make that fit hopefully. Fronts not to sure yet

[Taskmaster]

Rice.

[Hybridz0rz]

Originally Posted by TheAxiom

Rice.

How is fitting a new set of wheels defined as Ricer...

People these days, cry about everything...

[J-Spec Dan]

are you on stock suspension? have you had your rear fenders rolled?

as dick as this may sound: what research did you do on those fitments before buying them in those specs?

[Taskmaster]

Originally Posted by Hybridz0rz

How is fitting a new set of wheels defined as Ricer...

People these days, cry about everything...

Oversized wheels = Rice.