[SYLAR1978]

Hi,

Can anyone tell me how long takes updating all module in most connection with ista/p and icom.

Thkx

[Teq]

Programming takes a couple of hours depending on the ecu's.
Coding goes fast.

[cryptomit]

About 2 hrs.

[SYLAR1978]

OK Thank you.
I did it last night because i have many problem when i updated with k+dcan and winkfp.
It took 3,5 hours...and i am not an expert with istap. But finally i recover my rad cic cid and many other module. GW was in fault.

Other question, why istap tell me for many module = Programming/Coding and replacement.. (P / C / R / A)

[SYLAR1978]

I think my sp-daten are too old, i worked with ISSS_2.48.1_offline.
Can i update them or does exist a new version of isss offline compatible with my car E90LCI MY2010

[SYLAR1978]

And many module were downgrade. I will try with isip Next 2.54

[SYLAR1978]

Or 3.54...

Are this thé solution?

[Teq]

Originally Posted by SYLAR1978

OK Thank you.
I did it last night because i have many problem when i updated with k+dcan and winkfp.
It took 3,5 hours...and i am not an expert with istap. But finally i recover my rad cic cid and many other module. GW was in fault.

Other question, why istap tell me for many module = Programming/Coding and replacement.. (P / C / R / A)

Depends on the current software number.
Calculate test plan and upload it here or record your screen.

I wouldn't upgrade daten in an old version of ista-p. You need the whole package.

[SYLAR1978]

Originally Posted by Teq

Depends on the current software number.
Calculate test plan and upload it here or record your screen.

I wouldn't upgrade daten in an old version of ista-p. You need the whole package.

OK, i think for the first time by working with winkfp i did some mistake.

[Zack77]

Originally Posted by SYLAR1978

OK, i think for the first time by working with winkfp i did some mistake.

I was able to recode the modules that it stated needed replacement just by saying that I indeed had replaced them. You'll receive multiple dialogs, check the box and continue on. You will also be asked the part number in some instances (fairly easy to find). As long as you know the part numbers (remember it is possible that a part has been replaced by someone else and the factory part number may be incorrect); you should be fine. If you do everything correct and you're still prompted with replacements, then replace if you wish to code-or you have setup your cable wrong-which is not your case since you have fill communication it appears.

I would also suggest getting a newer version, with expert mode. 2.53.X shouldn't be hard to find but if you can't find it feel free to me me.

Just remember to verify the part numbers if you do choose to tell the program you've replaced the modules-this will obviously only work if they are indeed functional and an error was simply made. Most k+dcan adopted variants DO NOT have constant proper voltage reporting, therefore ensure you have a proper amount of power! Full update without iDrive over k+dcan cable has taken me generally about an hour, including coding afterwards.

[Teq]

Let ista-p fix your problems.

Use inpa function jobs aif or so to get a list of all the modules with vin, zusb etc. Upload that image as well.

[SYLAR1978]

Thank you guys. Fortunately I have took a photo before update them but i must find there. I found ISPI Next 3.54 and I think do the whole car; what is the maximum duration of the process please for whole car? The first time I used the cables as start the car my brother