|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Procede boost at gear change on auto
|
|
09-29-2009, 05:50 PM | #68 | |
Lieutenant Colonel
109
Rep 1,948
Posts |
Quote:
Thanks for the info though! |
|
Appreciate
0
|
09-29-2009, 05:58 PM | #69 | |
Colonel
184
Rep 2,841
Posts |
Quote:
Shiv is always up late....he's a night owl I'm sure he will come out with 6AT specific maps that address this issue. I know he's been trying to incorporate both MT and AT into one map for a little while now.....but somehow I think the AT's just pass more boost through on the upshift since we don't let off the throttle like the MT's do! |
|
Appreciate
0
|
09-29-2009, 06:11 PM | #72 | |
Lieutenant
8
Rep 450
Posts |
Quote:
I'll try to run it a bit harder to see if i can get replicate what you guys are seeing. MapII is 75%, will test it out on that if the conditions permit ( rain in wa state).
__________________
|
|
Appreciate
0
|
09-29-2009, 06:23 PM | #73 | |
Lieutenant Colonel
109
Rep 1,948
Posts |
Quote:
|
|
Appreciate
0
|
09-29-2009, 06:24 PM | #74 | |
Lieutenant Colonel
109
Rep 1,948
Posts |
Quote:
|
|
Appreciate
0
|
09-29-2009, 07:14 PM | #75 | |
Lieutenant
8
Rep 450
Posts |
Quote:
Llots of traffic. I found a small stretch where i used map2 at UT 75%.. WOT from about 15mph to about 90ish. 2nd to 3rd.. no issues, almost made it to 4th before i ran out of road. DTC on, weather about 60 degrees. Everything else default.
__________________
|
|
Appreciate
0
|
09-29-2009, 07:32 PM | #76 |
Private First Class
24
Rep 142
Posts |
NO LIMP. DS Mode. 7-29 w/ appropriate FW: Stage 1 6AT. All default settings except o2 sim: 80%. I did not mess with upshiftsoftening this time. Car does not pull like test11 or 9-9 maps on stage 3though I miss the quick shifts (when the car didn't limp)
I haven't successfully WOT like that in a long time. |
Appreciate
0
|
09-29-2009, 07:48 PM | #77 | |
Lieutenant Colonel
109
Rep 1,948
Posts |
Quote:
I switched back to the 9-9 maps for the time being. I know i get limp mode but i'm liking the power and it is a major difference! Once i have all my mods installed, i'll let you know how i make out with the maps. |
|
Appreciate
0
|
09-29-2009, 07:50 PM | #78 | |
Lieutenant Colonel
109
Rep 1,948
Posts |
Quote:
|
|
Appreciate
0
|
09-29-2009, 07:52 PM | #79 | |
Private First Class
24
Rep 142
Posts |
I'm switching back to 9-9 Stage 3 as well, and going to increase the upshiftsoftening to see if that helps out. After going to quick shifts and dtc map switching....can't ever go back again. Stage 1 is just redonkulous.
Quote:
|
|
Appreciate
0
|
09-29-2009, 08:41 PM | #80 | |
Lieutenant
8
Rep 450
Posts |
Quote:
Gas is chevron btw.. probably doesnt matter but throwing it out there.
__________________
|
|
Appreciate
0
|
09-29-2009, 10:20 PM | #82 |
Lieutenant Colonel
109
Rep 1,948
Posts |
|
Appreciate
0
|
09-30-2009, 08:32 PM | #83 |
Lieutenant
8
Rep 450
Posts |
Tried 79% on stage one... no probs at all. 0-75mph 2-3rd, and a 3-4rd pull... no misfires noticed. Temps were in the high 40's/low 50's.
My fuel pump is about a month old.. if that makes a diff.
__________________
|
Appreciate
0
|
09-30-2009, 08:59 PM | #84 | |
Lieutenant Colonel
109
Rep 1,948
Posts |
Quote:
Whats your boost showing as? It was raining yesterday so i didn't run but will probably go out tonight. I don't think its a fueling issue for me. Other codes would pop up if it was a fuel issue. I haven't had any codes as of yet on my car with the 7-29 stage 1 map. |
|
Appreciate
0
|
09-30-2009, 09:04 PM | #85 |
Captain
49
Rep 704
Posts |
Ran 74% UT, 80% IgCor, and 0 Upshift. 60°F Ran 1st through 4th 3 or 4 times. No CEL or Misfires. I think the misfire was coming from higher air intake temps now that it's cooler out problem solved.
__________________
|
Appreciate
0
|
09-30-2009, 09:06 PM | #86 |
Lieutenant Colonel
109
Rep 1,948
Posts |
|
Appreciate
0
|
09-30-2009, 09:40 PM | #87 |
Captain
49
Rep 704
Posts |
same ones. 9-9 and stage 1
__________________
|
Appreciate
0
|
Bookmarks |
|
|