|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Aftermarket clutch done your own?
|
|
10-01-2016, 05:21 PM | #1 |
Lieutenant Colonel
119
Rep 1,525
Posts |
Aftermarket clutch done your own?
So has anyone done their own clutch change? If you did what did you do with the pilot bearing shaft that's pressed on the oem flywheel? below is what i think not necessarily correct feel free to correct me!
When you remove the pilot bearing shaft from the old fw the entire assembly comes out so the shaft and the circular piece that has the holes in it looks to be one piece. But that entire assembly will not fit on the new fw you have to separate the shaft from the circular piece then press the shaft to the new fw? also does the shaft go seated all the way on the new fw or is it suppose to stick out at the same height as it did on the oem fw?
__________________
2008 335i FFTEC ST 6266,), Boostbox, VRSF 3.5 exhaust, mtech front and rear, KWVll, APEX 18x9.0, 18x12= 305/35/18 NTO1s, BMS OCC, Rb PVC, M3 tri-color stitched S-wheel,MT SWAPPED, M3 LSD diff
2008 135i mods coming soon! |
10-01-2016, 06:38 PM | #2 |
Lieutenant Colonel
119
Rep 1,525
Posts |
Never Mind I Got My Answer!
__________________
2008 335i FFTEC ST 6266,), Boostbox, VRSF 3.5 exhaust, mtech front and rear, KWVll, APEX 18x9.0, 18x12= 305/35/18 NTO1s, BMS OCC, Rb PVC, M3 tri-color stitched S-wheel,MT SWAPPED, M3 LSD diff
2008 135i mods coming soon! |
Appreciate
0
|
10-02-2016, 12:38 PM | #4 |
Lieutenant Colonel
119
Rep 1,525
Posts |
seperate it and push the shaft all onto the flywheel until it seats
__________________
2008 335i FFTEC ST 6266,), Boostbox, VRSF 3.5 exhaust, mtech front and rear, KWVll, APEX 18x9.0, 18x12= 305/35/18 NTO1s, BMS OCC, Rb PVC, M3 tri-color stitched S-wheel,MT SWAPPED, M3 LSD diff
2008 135i mods coming soon! |
Appreciate
0
|
Bookmarks |
|
|