[jannisa]

I just received my ar occ with these clamps and connectors :



Am I missing a second connector like this or anything else connectors-wise?



In case I will head to install it on the drivers side will I need U-shape connectors for the pcv inlet and outlet port or is the tube supplied capable to hold a bend?

Thanks

[stratplaya06]

They are capable of holding a bend, but I just went to advance and got a few 90 degree 3/4" heater hose fittings and worm drive clamps. This way there are no kinks at all and the flow is really not altered too much.

I just put mine back on with a new driver side bracket, as I was really unhappy with the way the passenger side bracket worked, and I am really happy so far. It looks great in the engine bay and I am not burning holes in the tubes from all of the hot parts on the passenger side like I was before.

[ar design]

You accidentally got two rubber connectors you only need one.

[Craig@SupremePower]

where's mine??

[jannisa]

Thank you all for your replies.
@stratplaya : Do you collect the same amount of oil now that you relocated the occ and have those 90 degrees bends in the way?

[stratplaya06]

I noticed that the filter was brown when I removed the OCC, but it did not have any oil in the reservoir. With that said, I had a hose with a hole in it from the exhaust heat shield, so I don't think I am an accurate test. I will be checking the catch can for oil in the next 1-2k miles so I will post back with what I collect.