[chanlon1]

So I managed to get the T15 torx screws off the angel eye bulb holders.

I'm looking to swap the unit for a LED one, but am curious about the connection on the back.

The existing holder has a connector as shown in the attached picture.

Having researched a variety of different LED's, it appears that they all have a different connection to the existing one, yet they all say "plug n play, no mods required etc".

Can anyone recommend any LED's that will connect to the existing connector and not require me to attempt soldering, splicing or any fancy modifications?

thanks
Colin

[mowflow]

When I was going to do this mod I read that the new Mtech ones were direct plug n play. The info was deep within a thread on here somewhere.

[chanlon1]

I'll start digging around then for Mtec....

I just noticed another thread http://www.e90post.com/forums/showthread.php?t=514318 that is advertising what I'm looking for for my 2010 E91 LCI.

I've posed a similar question there as they specifically state "plug and play etc"...will be curious to hear a response


thanks

[mowflow]

I'm pretty sure the ones from Juiced Up are only for Xenons.

[chanlon1]

my mistake...wrong link! It should have been http://www.e90post.com/forums/showthread.php?t=514318


Must correct original post

[neil@JuicedUpTuning]

Originally Posted by mowflow

I'm pretty sure the ones from Juiced Up are only for Xenons.

We do both...pre lci with Xenon and LCI Halogen...and use the same LEDs

Thanks to chanlon1...we have a great independent customer review here...

http://www.e90post.com/forums/showthread.php?t=540404