[Dan-]

Hi people, was wondering if anybody has done this yet, I'm thinking of looking into it as I wouldn't mind a challenge, obviously the Rev counter will only go to 5k but other than that I see no reason why it won't work?

I rewired my Scooby dash to accept the latest model sweeping dial so it's not the unknown for me

[Phil325i]

Send a PM to M5rius, he's converted a non-M cluster to look like an M.

[makkan00]

Originally Posted by Dan-

Hi people, was wondering if anybody has done this yet, I'm thinking of looking into it as I wouldn't mind a challenge, obviously the Rev counter will only go to 5k but other than that I see no reason why it won't work?

I rewired my Scooby dash to accept the latest model sweeping dial so it's not the unknown for me

You cannot fit an OEM M3 cluster into 335D without changing EPROM chip, writing your car's vin and mileage + coding. If you have removed EPROM chips in the past and wrote the stuff onto that, then yes you can do it.
or Pay approx 500 euros to guys living in eastern european countries and they will make it PNP.

However, you can make your own speedometer to 'M3 replica' or copy of M3 as mentioned above. If you go down that route, nothing is better than using genuine M3 needles.

Good luck Dan.

[dy63]

Originally Posted by makkan00

You cannot fit an OEM M3 cluster into 335D without changing EPROM chip, writing your car's vin and mileage + coding. If you have removed EPROM chips in the past and wrote the stuff onto that, then yes you can do it.
or Pay approx 500 euros to guys living in eastern european countries and they will make it PNP.

However, you can make your own speedometer to 'M3 replica' or copy of M3 as mentioned above. If you go down that route, nothing is better than using genuine M3 needles.

Good luck Dan.

i remember a PM you said you use genuine M3 led for speedo. can you sell some to me?

[Dan-]

Originally Posted by makkan00

You cannot fit an OEM M3 cluster into 335D without changing EPROM chip, writing your car's vin and mileage + coding. If you have removed EPROM chips in the past and wrote the stuff onto that, then yes you can do it.
or Pay approx 500 euros to guys living in eastern european countries and they will make it PNP.

However, you can make your own speedometer to 'M3 replica' or copy of M3 as mentioned above. If you go down that route, nothing is better than using genuine M3 needles.

Good luck Dan.

Thanks for that, the main reason I want genuine M3 cluster is mainly the oil temp gauge I f***ing hate that swingometer MPG shite, what a waste of cluster space!

Might have to go down the route of as you say DIY my own (M3 Style) cluster!

Dan

[Dan-]

Originally Posted by Phil325i

Send a PM to M5rius, he's converted a non-M cluster to look like an M.

Thanks Ill send him a PM, see if its worth paying someone for when I haven't got time due to work or just work on it, bit by bit

Dan

[Sensible_]

It's no problem. If you find a speedo with less mileage than your own vehicle you can change the VIN in eeprom without touching a soldering iron by using a test clip and R270 programmer. Total expense would be £50 + whatever you pay for the used speedo.

If the KOMBI has a higher mileage you'll need to desolder chip and reset it. This is important as the CAS module will always take the highest mileage present.