ECS strut bar install

TGTIW · 09-23-2013, 09:00 AM

I've recently installed the ECS carbon strut bar on my 2010 328i and it makes contact with the underside of the hood. I want to confirm that I've installed the bar correctly.

Also, I have a question regarding the actual design of the bar and it's mounting brackets. With the strut tower plates bolted in place, if I place the bar in it's position, should the mounting surface of the bar and the mounting surface of the plates be flush? If I bolt one side, the angle of the mounting point on the strut tower plate forces the other side of the bar up. So if both sides of the bar are torqued down, there is a certain amount of bending placed on the bar. Is this correct? This photo shows the bar with one side bolted in place.

ECSTuning · 09-23-2013, 09:58 AM

TGTIW you have a PM.

-James

melloww22 · 10-30-2013, 07:28 PM

that doesnt look correct, what torque setting did you use?

TGTIW · 11-03-2013, 04:50 AM

For the photos everything was essentially finger tight, unfortunately it seems to be a manufacturing issue. ECS was great as far as issuing a quick refund, I would have liked to have been able to get the bar to work though.

09-23-2013, 09:00 AM	#1
TGTIW Second Lieutenant 130 Rep 245 Posts Drives: 2010 328i Join Date: May 2013 Location: Knoxville iTrader: (2)	ECS strut bar install I've recently installed the ECS carbon strut bar on my 2010 328i and it makes contact with the underside of the hood. I want to confirm that I've installed the bar correctly. Also, I have a question regarding the actual design of the bar and it's mounting brackets. With the strut tower plates bolted in place, if I place the bar in it's position, should the mounting surface of the bar and the mounting surface of the plates be flush? If I bolt one side, the angle of the mounting point on the strut tower plate forces the other side of the bar up. So if both sides of the bar are torqued down, there is a certain amount of bending placed on the bar. Is this correct? This photo shows the bar with one side bolted in place.
	Appreciate 0 Tweet Quote

09-23-2013, 09:58 AM	#2
ECSTuning New Lifetime Replacement Policy 814 Rep 11,738 Posts Drives: Independent Tuning Specialists Join Date: Jul 2008 Location: Ohio iTrader: (18)	TGTIW you have a PM. -James
	Appreciate 0 Quote

10-30-2013, 07:28 PM	#3
melloww22 Captain 105 Rep 955 Posts Drives: 2011 335i E90 Join Date: Apr 2011 Location: San Diego iTrader: (1)	that doesnt look correct, what torque setting did you use?
	Appreciate 0 Quote

11-03-2013, 04:50 AM	#4
TGTIW Second Lieutenant 130 Rep 245 Posts Drives: 2010 328i Join Date: May 2013 Location: Knoxville iTrader: (2)	For the photos everything was essentially finger tight, unfortunately it seems to be a manufacturing issue. ECS was great as far as issuing a quick refund, I would have liked to have been able to get the bar to work though.
	Appreciate 0 Quote