[tawfeeqh]

Hi Guys

I am after the "loom extension or Tmap adaptor" for the n20 tmap sensor. If anyone has one that they can sell me (if you don't need to install on your own car straight away) then I can purchase from you and install on my car immediately as my car is currently in the workshop getting the turbos installed.

I think it takes a week or so if I order from BMS directly

Thanks

Tawfeeq

[tawfeeqh]

Got one from JD75

Life saver Justin

Cheers

[_ink]

What sensor did you buy that wasn't long enough?

[tawfeeqh]

Originally Posted by _ink

What sensor did you buy that wasn't long enough?

Standard n20 3.5 Bar Tmap sensor

https://www.ecstuning.com/b-genuine-...r/13627843531/

[tawfeeqh]

And so I needed the adaptor in this link below

6th item from the top

http://burgertuning.com/N54_JB4_upgrades.html

[_ink]

Ah, I bought mine from BMS, didn't actually know you could buy anything else. Lol

[tawfeeqh]

Originally Posted by _ink

Ah, I bought mine from BMS, didn't actually know you could buy anything else. Lol

lol - I got my one from a forum member that decided to not go ahead with his build. At the time he bought a maxboost adaptor to do the non-linear scaling past 21-22 psi. However now MHD Map Voltage Scaling allows a non-linear scaling to the N20 TMap sensor so that you can actually tune for boost higher than 21-22psi. This takes the place of the old "MaxBoost" device which was doing this same thing. It is handled fully in software now, providing much smoother scaling and flexibility.

Hence I need the adaptor to hook it up