|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Broken Oxygen sensor connector
|
|
10-11-2012, 11:43 AM | #1 |
Railside Performance
48
Rep 331
Posts
Drives: E92 M3 R8 V10 Q5
Join Date: Nov 2009
Location: Railside Performance
iTrader: (8)
Garage List 2010 Ducati Streetf ... [7.00]
2017 Q5 [0.00] 2017 BMW R NineT Racer [5.00] 2010 Audi R8 V10 Ma ... [0.00] 2008 M3 [10.00] |
Broken Oxygen sensor connector
I was throwing a code for bank1 after cat and upon removing the connector, I noticed it was wet inside and that one of the four pins were broken (orange) with green slime everywhere Is there a quick fix for this or will the whole connector that holds 3 sensors need to be replaced?
|
10-11-2012, 10:03 PM | #2 |
Enlisted Member
0
Rep 41
Posts |
If you own a soldering iron then splice a wire in to bypass that pin on the connector. If you don't know how to solder then replacing the harness may be better.
Have fun. |
Appreciate
0
|
Bookmarks |
|
|