[Davidlindsey]

I have had my abs hydraulic pump replaced and they have forgot to reset the computer thingy, so now i have the tyre pressure symbol up in red all the time, can some one tell me how to reset it please so it turns off.
I have searched on here, found a couple of things but none have worked.
Thankyou
D

[xPETEZx]

USe the Stalk button to navigate to Tyre Presure reset.

Then hold the button down for 5-10 seconds, till a big Tick symbol appears.

I had this same issue. I would press "reset" but it would just come back once I drove off.
Turned out I wasnt pressing the button long enough!

[Edi1011]

If you have IDrive Press Menu button
Select 'SETTINGS' and Press the Controller
Select 'VEHICLE/TYRES' and Press Controller again
Scroll until 'FLAT TYRE MONITOR' is selected
Start Engine but do not drive away yet
Select 'CONFIRM TYRE PRESSURE' and Press Controller
Select 'YES' and Press Controller
You can then drive off

Hope that helps you

[Davidlindsey]

thankyou guys, turns out i just wasn't pressing the button for long enough