[uksoundz]

Hi,

I have a 2007 320d with 90k on the clock. I recently got the inpa software, and hooked it up last night, when I read the codes tons of codes appeared. I deleted these and have driven the car all day today, around 60 miles. I rechecked, and it looks like 3 error codes remain, so hopefully the others were somewhat spurious, oh and I currently have no warning lights on the dashboard.

I'm unsure what they mean, but I'm thinking some might be for the glowplugs because when it was cold the car smoked a lot and missfired on startup.

The codes are as follows
JBBF - A6DE - 24
DME/DDE - 4212- 24
DME/DDE - 4242 - 24
CAS - A0B3 - 28


Any help must appreciated!

[gewse2k]

A6DE (Mirror/spray-nozzle heating,left)
4212 (Glow plug ,cylinder 1)
4242 (Glow plug ,cylinder 4)
A0B3 (Starter motor, terminal 50)


plugs and starter motor could be due to the cold and short drives//not driving for a while.
heater for the spraynozzle heater can be ignored, but should just be replaced.

[uksoundz]

Originally Posted by gewse2k

A6DE (Mirror/spray-nozzle heating,left)
4212 (Glow plug ,cylinder 1)
4242 (Glow plug ,cylinder 4)
A0B3 (Starter motor, terminal 50)


plugs and starter motor could be due to the cold and short drives//not driving for a while.
heater for the spraynozzle heater can be ignored, but should just be replaced.

Thanks for this. I noticed the car sounded groggy and smoked a lot on startup.
I drive the car 60 miles a day do it gets plenty of use.
Ill change the plugs, is this likely to cure the starter motor problem? Or what else could it be?
Also where is the heater located?
Thanks

[ivibmw]

where did you find the errors from the hex code listed?

is there a list somewhere?

[jimmy1022]

after lurking for a while though I had make the effort!
Enda has a good list on his site:

http://www.endtuning.com/bmwcodes.html#DDE6