[geared]

I had a chance to do some driving since the installs (ISO New Hex-C, and Intercooler) I am throwing a few codes, and hoping you can help:

n55
6 spd
jb4 iso - map 5 - settings as per Terry's post - newest firmware
ar 4 inch nocts
aa sport intercooler
cpe chargepipe
bms intercooler
e40 mix with 93

Codes:

3BCC - PT-CAN, message (IHKA control unit):missing - ??????

36fd - see below.

MEVD17.2-BN2000
0x36FD
14077
DME main relay: implausibly open
The diagnostic function monitors the switch status of the main DME relay.
The fault is recognized when the switched status is implausible.Potential problem source(s): - Defect in wiring harness to DME main relay - Defective DME main relay
fault debouncing - Allow DME to enter sleep mode 3 times - will this fix the issue and if so, HOW CAN I DO THIS?
Terminal 15
Voltage condition:- Onboard electrical system voltage between 9 V and 16 VTemperature condition:- NoneTime condition:- NoneOther conditions:- none
- None
- None
NO
U
N
- Defect in wiring harness to DME main relay - Defective DME main relay
- Check wiring harness to DME main relay- Replace DME main relay


Thanks,

[geared]

bump edited to remove the ones I was told were normal.....

[geared]

Bueller?

[geared]

i think i figured it out

[SRT14PimPin07]

Originally Posted by geared

i think i figured it out

Let us know what the problem and solution was.

[bulldog_yyc]

bad wiring?

[geared]

note the "i think"

What i think happened:

the first code was thrown as a result of my issue with Fuse 77 - see my other post

the second code i believe I tripped as a result of resetting the battery several times in a short period of time while messing with some other things....just freaked the dme out I think.

Again, this is what I think happened, and I could be completely wrong. We will see if the codes come back.....

jb

[Chris1337]

Kinda late but having a similar issue, what was the solution? Getting the DME code