[badsha]

is there any DIY for how i can buypass my E90 318d/320d 2006 mod or is it not possible without fault codes??

[badsha]

Does not anyone of guys done egr delete???

[donsentenza]

hi , yes i'v done it on a 320d N47 engine and unfortunately i didnt take pictures, anyways here is a pic of what you have to close down that's all

Uploaded with ImageShack.us

after doing so i got no fault codes on my odb just i can hear something like the turbo but it's not the turbo and that only when the windows are closed.i dont know if you can pass the controle test with this on or not ,fortunately here in morocco i can still pass it . enjoy

[E90jonno]

What's the point?

[badsha]

thannk u m8 but i have a M47 engine so i think its a diffrent as N47 came in 2008?

and the point of doing this help ur engine live much loonger, but i dont know how its done on M47d2tu engine:S

[donsentenza]

mate i think it's almost the same look at this pictures of your engine...


Uploaded with ImageShack.us
the hole to close down is almost the same on both engine mate


Uploaded with ImageShack.us

[badsha]

thnk u very much for help m8!!! i aprishate that very much


so blokking the hole there will give me no faults right and i will get rid of the problem with slugg inside the airtake right?

[donsentenza]

yes exactly mate you wont have any bad thing. the EGR will work as it was before but your engiine wont recycle used gaz anymore.good luck

[badsha]

thank u again m8 didi u use any spesial thing to do the blockage? as glue or stainless steel etc?

[donsentenza]

i used a piece of bronze, it cost me around 10$ ,dont use glue, use metal or somthing that can resist to the heat.

[E90jonno]

Will this increase power then seeing as the engine will be cleaner?

[badsha]

this will not increase the engine power, but ur engine will breathe much easier and sound much better, and likly to go a bitt better due the clean cold air against the hot air from the exhaust.

[dziqsek]

Sounds better?? How come? What you mean -"better"??

I have 2008 318d n47 and after reading this i want to do it, but I need pros and cons

[amullo]

Normally an EGR delete doesn´t do much for power, but it might give you abit better fuelconsumption since your not burning spend exhaustgases but only clean air.

The problem is that most modern EGR´s have a "cut out" that stops exhaustgas from entering the intake when you have full throttle to increase power. On older gasoline engines this easy to control, since it was vacuum controlled. Low pressure inside the intake increased the spent gas use (EG. coasting would burrn more exhaust gases).

The pros are better fuel milage and maybe midrange torque.
The cons: Illegal to mess with this stuff in most countries. Your car will fail inspection if they do an exhaust gas check. No "real" cons on the mechanical side.

I did a EGR delete on my old E46 -02 320d and drove it for 100.000K´s with no issue. Same setup as this. I´m thinking about it on my e91, i just want the new car garantee to run out before i mess with anything.

[guliermu]

hello friends i buy an egr by pass if we fits it did switch any fault on dach ? 10x

[rod]

hi,
i have one 320 ED 6mt N47N (2010/10)
i sealed the pipe(part 21) nearby the inlet manifold,
but it shows the engine error signal,
I guess that error is caused by the temperature sensor on the part 21,
but i can't sure.
it means i can not seal it or just wrong position?
N47 320D has the temperature sensor nearby the manifold?
i check the EGR(AGR) figure between both two cars, it's different
i have no idea of it, thanks for your help ^^

[bennyyko2013]

Originally Posted by rod

hi,
i have one 320 ED 6mt N47N (2010/10)
i sealed the pipe(part 21) nearby the inlet manifold,
but it shows the engine error signal,
I guess that error is caused by the temperature sensor on the part 21,
but i can't sure.
it means i can not seal it or just wrong position?
N47 320D has the temperature sensor nearby the manifold?
i check the EGR(AGR) figure between both two cars, it's different
i have no idea of it, thanks for your help ^^

+1

[makaveli the don]

Originally Posted by donsentenza

hi , yes i'v done it on a 320d N47 engine and unfortunately i didnt take pictures, anyways here is a pic of what you have to close down that's all

Uploaded with ImageShack.us

after doing so i got no fault codes on my odb just i can hear something like the turbo but it's not the turbo and that only when the windows are closed.i dont know if you can pass the controle test with this on or not ,fortunately here in morocco i can still pass it . enjoy

Thank u donsentenza for your explanation.. I just need to know where I can find someone to make piece of bronze to bypass my egr . Thanks in advance