|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Setting up LC-1 with Procede
|
|
09-19-2012, 10:15 AM | #1 |
Not Baned
86
Rep 1,352
Posts |
Setting up LC-1 with Procede
HEy guys,
I have an Innovate LC-1 Wideband Controller and I was told that you could feed the LC-1's 0-5v analog output into the Procede's rear o2 sensor input. So, I know there is a way to hook it up to your Procede harness I just don't know where exactly the rear o2 sensor input would be on the harness. Any help would be greatly appreciated guys!
__________________
FFTEC 900 - 6466 | PR PI Stg4 | Motiv Tune/BB/FF | Spec Stg 2+ | Quaife LSD | DSS Half-shafts
VRSF Race IC | VRSF Charge Pipe | Evo Dual Oil Cooler | BC Coilover | To be continued... |
09-19-2012, 10:58 AM | #2 |
Banned
16
Rep 335
Posts |
why would you want to incorporate an innovative lc-1? the procede has an o2 modifier included, for passing emissions with catless downpipes. you just need to modify the harness to enable it.
otherwise, not really sure why you would want to use the innovative with the procede. |
Appreciate
0
|
09-19-2012, 11:12 AM | #3 | |
Not Baned
86
Rep 1,352
Posts |
Quote:
__________________
FFTEC 900 - 6466 | PR PI Stg4 | Motiv Tune/BB/FF | Spec Stg 2+ | Quaife LSD | DSS Half-shafts
VRSF Race IC | VRSF Charge Pipe | Evo Dual Oil Cooler | BC Coilover | To be continued... |
|
Appreciate
0
|
09-19-2012, 11:23 AM | #4 | |
441
Rep 18,331
Posts |
Quote:
|
|
Appreciate
0
|
09-19-2012, 11:38 AM | #5 |
Not Baned
86
Rep 1,352
Posts |
The controller comes with a new o2 sensor, you just have to weld in a new bung.
__________________
FFTEC 900 - 6466 | PR PI Stg4 | Motiv Tune/BB/FF | Spec Stg 2+ | Quaife LSD | DSS Half-shafts
VRSF Race IC | VRSF Charge Pipe | Evo Dual Oil Cooler | BC Coilover | To be continued... |
Appreciate
0
|
09-19-2012, 11:48 AM | #7 |
Lieutenant Colonel
76
Rep 1,883
Posts |
I think FBIS has one of these on his car. There are a couple of others too. I'd search it and send them PMs.
__________________
Legal Disclaimer: Anything I or anyone else says about my vehicle on this website(e90post.com or any affiliated or nonaffiliated sites), pertaining to modifications, is only to gain acceptance from my/our peers, and does not actually represent anything actually existing on my car, and thus, cannot be held against me in any issues, i.e. warranty claims, that may arise.
|
Appreciate
0
|
09-19-2012, 01:25 PM | #8 |
1737
Rep 17,960
Posts
Drives: A Lot
Join Date: Sep 2006
Location: SF Bay, CA
iTrader: (0)
Garage List 2018 Ducati Panigal ... [0.00]
2016 Mazda CX5 [0.00] 2017 Aprilia Tuono ... [0.00] 2019 BMW M2 Competi ... [0.00] 2015 BMW M5 Competi ... [10.00] 2016 Ducati XDiavel S [0.00] 2016 AMG GT S [0.00] 2011 Ferrari 458 It ... [0.00] 2017 Charger Hellcat [0.00] 2015 KTM Super Duke ... [0.00] 2016 KTM RC390 [0.00] |
Hi guys-- ill post up a how to later today once I get behind a computer.
|
Appreciate
0
|
09-19-2012, 04:03 PM | #9 |
Major General
307
Rep 5,175
Posts |
I have an FJO wideband and it integrates perfectly with the Procede.
__________________
654 RWHP ... ! Vishnu/FFTEC Single Turbo 335
|
Appreciate
0
|
09-19-2012, 05:19 PM | #10 |
Not Baned
86
Rep 1,352
Posts |
Thanks Shiv!
__________________
FFTEC 900 - 6466 | PR PI Stg4 | Motiv Tune/BB/FF | Spec Stg 2+ | Quaife LSD | DSS Half-shafts
VRSF Race IC | VRSF Charge Pipe | Evo Dual Oil Cooler | BC Coilover | To be continued... |
Appreciate
0
|
09-20-2012, 02:59 PM | #11 |
Banned
7
Rep 419
Posts |
More info can be found here: http://www.e90post.com/forums/showthread.php?t=747483
|
Appreciate
0
|
Bookmarks |
|
|