[Will@P]

Hello everyone! Some of you may already know us, but we are officially a sponsor here on bimmerpost. Performance Race Solutions is located in Sanford, FL. just outside of Orlando. We offer everything in house: Service, alignments/corner balance alignments, mustang dyno with our very own tuner, fabrication, and a full machine shop. We also prep vehicles for track days and offer track support for any of the local tracks. We work on every vehicle that comes through our doors. Most of our clientele are EVO's, VW's, Audi's, Porsche, and BMW's.

We specialize in OE replacement and vast aftermarket parts and will beat/match prices.

We are located at:

4150 St. Johns Pkwy. Suite 1000
Sanford, FL. 32771

For direct inquiries you can contact me at:

Will@Performanceracesolutions.com

or call the shop: 407-878-5870

We are open Monday-Friday from 9am-6pm but are usually still here after hours.


Stay tuned for what we have in store for you guys: dyno days, meets, special BMW group buys.

Check out our website (BMW Section currently underconstruction):

Performanceracesolutions.com

Like us on Facebook:

http://www.facebook.com/#!/prs.tuning.7

[Will@P]

Here are pictures of our shop life.

Our shop track car:







Active Supercharged M3 with lots of surprises:





Subframe reinforcement:



E60 M5 getting custom headers and clutch install:



One NASTY RX7:





Machining:

[Will@P]

The Porsches:







Can't forget the Lambo's:







After a long day we park all of the children inside:

[MikeCOUPE]

Nice shop. If only you were closer!

[BoostAddict]

Welcome! I feel like I saw that FD at cars and cafe in Lake Mary a few years back.

[MiloMia]

niceeee.

[Dickson]

Holy shit the turbo on that RX-7 is fucking insane.

Good looking shop, and cars.

[Will@P]

Originally Posted by MikeCOUPE

Nice shop. If only you were closer!

Miami is not to bad of a drive We have a few EVO customers that drive down from Georgia to get work done.

[Will@P]

Originally Posted by ***********

Welcome! I feel like I saw that FD at cars and cafe in Lake Mary a few years back.

You most likely did, we try and go to some of the C&C meets which are now here in Sanford.

[EDM92]

It's great to see you on here as a sponsor now Will! This guy seriously knows his BMWs inside and out. Looking forward to future meets at PRS!

[Will@P]

Originally Posted by BMWorNOTHING

It's great to see you on here as a sponsor now Will! This guy seriously knows his BMWs inside and out. Looking forward to future meets at PRS!

Thanks Alex! We are planning a few things for you guys this summer. Stay tuned for our first group buy.

[fasteddie222]

Now we are talking!!!

[Will@P]

At Performance Race Solutions Not only do we offer quality parts, but we can give you advice on setting up your suspension. With years of real world driving experience and countless hours of track time, we know what works.


We carry Eibach, Tein, H&R, AST, KW, and BC Racing coilovers. If you don't see a product your looking just ask and we can acquire it for you.



PM me or call for pricing on any of the kits we have available to offer. 407-878-5870

We are now offering 25% OFF suspension installs on all of our products until June 1.


Performance Race Solutions is now a dealer for Burger Motorsports Tuning products.

PM for pricing on installs


http://www.burgertuning.com/

[Will@P]

Agency Power Downpipes BMW 135i/335i 08+

ON SALE!!!

PM me for special pricing

WWW.PERFORMANCERACESOLUTIONS.COM

Agency Power downpipes are designed to improve your turbo charged vehicles performance. Agency Power’s BMW E92 335I downpipes are no exception. These pipes are made from polished 304 stainless steel. They connect to the headers with a 3" diameter opening and V band flange. They have an inside diameter of 2.60”. The larger diameter design will improve exhaust flow, keep boost pressure up and provide improved throttle response. This down pipe eliminates the catalytic converters. Each down pipe has 2 oxygen sensor locations. Thick flanges, sturdy hangers and increased flow make these down pipes a must have for all E92 enthusiasts.







Agency Power's downpipes are designed to improve your turbo charged vehicles performance. These pipes are made from polished 304 stainless steel. The N55 engine runs a single turbo setup as the predecessor to the N54 twin turbo engine. It connects to the single turbo like stock with a V-Band clamp and then connects to the section 1 mid pipes. The downpipe has an inside diameter of 4" with 2.5" flanges. The larger diameter design will improve exhaust flow, keep boost pressure up and provide improved throttle response. This down pipe eliminates the catalytic converter. With the reduced back pressure, the exhaust will have a slightly different tone and the overall driving performance will be noticed. The down pipe has two oxygen sensor bungs so you can retain the factory inputs. An ECU Flash is recommended to maximize the performance of your car. Thick flanges, sturdy hangers and increased flow make these down pipes a must have for all 135i and 335i enthusiasts with the single turbo N55 cars.

[Will@P]

Need Genuine OEM BMW parts for a great price? Look below!

Happy friday everyone and have a great weekend!


http://www.e90post.com/forums/showth...3#post12119373

[Lulz_M3]

You guys planning on offering Cobb Protunes?

[EDM92]

Originally Posted by Lulz_M3

You guys planning on offering Cobb Protunes?

Yeah Will, you guys should definitely look in to that!

[Will@P]

Originally Posted by Lulz_M3

You guys planning on offering Cobb Protunes?

We have a few things in the works right now with some new companies, but Cobb BMW has been brought up. We currently have the Cobb Tuner Pro for Subaru's.

If I can get 4-5 members interested I can make it happen sooner than expected. To give you guys an idea our rate is $500 for dyno tuning.

[Lulz_M3]

Originally Posted by Will@PRS

We have a few things in the works right now with some new companies, but Cobb BMW has been brought up. We currently have the Cobb Tuner Pro for Subaru's.

If I can get 4-5 members interested I can make it happen sooner than expected. To give you guys an idea our rate is $500 for dyno tuning.

Here is a thread gauging interest in Cobb protunes from another shop in southern Fl, i think the interest is there.

http://www.e90post.com/forums/showthread.php?t=696950

If we can get 5 members with deposits in place for a protune, will you guys make the investment in the software?

In regards to your pricing, is that $500 for one map including dyno time? I am looking for two protuned maps:

1) Meth + 93 oct map.
2) 50:50 E85/93 + Meth map

What do you suspect something like this would cost? We can talk pricing in PM me if you would like.

[Will@P]

Originally Posted by Lulz_M3

Here is a thread gauging interest in Cobb protunes from another shop in southern Fl, i think the interest is there.

http://www.e90post.com/forums/showthread.php?t=696950

If we can get 5 members with deposits in place for a protune, will you guys make the investment in the software?

In regards to your pricing, is that $500 for one map including dyno time? I am looking for two protuned maps:

1) Meth + 93 oct map.
2) 50:50 E85/93 + Meth map

What do you suspect something like this would cost? We can talk pricing in PM me if you would like.

Yes we can do that, minimum of 4. $500 is for 1 map full day dyno time. Each additional map is $250.

If we can get more people involved I can work out on the price for additional maps. Keep in mind you need to have the Access Port to be able to run the Tuner Pro.

[Will@P]

Here is an EVOX we tuned a few weeks back after we built the engine and upgraded the turbo.

[Will@P]

Another EVOX with a similar setup.