[335okc]

can i buy this tank cap? im curious

[Slops]

Originally Posted by 335okc

can i buy this tank cap? im curious

I don't think so, maybe send an email to snow perf with your request.

[Bimmer305]

Is that a hole?

[Slops]

Originally Posted by Bimmer305

Is that a hole?

I don't think so... I'll put it on tight today and see if I can suck air out of the meth port at the bottom of the tank, then I'll know for sure.

[Slops]

Originally Posted by Sloppy

I don't think so... I'll put it on tight today and see if I can suck air out of the meth port at the bottom of the tank, then I'll know for sure.

It is vented, even though you can't see holes

[Slops]

Originally Posted by Bimmer305

Is that a hole?

Yes, that's a gap where it vents

[Bimmer305]

Originally Posted by Sloppy

Yes, that's a gap where it vents

Mystery solved lol

[Slops]

Originally Posted by Bimmer305

Mystery solved lol

Yay!!!

[Slops]

Originally Posted by M3_Lulz

Can you pressurize the tank to see if it is one way?

Yeah I sucked air out and blew air in, both times it leaked so it's def not a one way

[Former_Boosted_IS]

Originally Posted by Sloppy

Yeah I sucked air out and blew air in, both times it leaked so it's def not a one way

Sloppy, you are testing the valve under MUCH higher pressure than the meth vapors will ever place on that cap. Turning the tank over and allowing the fluid to place pressure on that tank cap is not real world. I am not 100% sure, but in my opinion I think it was designed as a one way valve to allow air in to avoid suction pressures on the tank, but not allow methanol vapors to release. This is simply my experience from using this tank for a couple of years.

[Slops]

Originally Posted by Former_Boosted_IS

Sloppy, you are testing the valve under MUCH higher pressure than the meth vapors will ever place on that cap. Turning the tank over and allowing the fluid to place pressure on that tank cap is not real world. I am not 100% sure, but in my opinion I think it was designed as a one way valve to allow air in to avoid suction pressures on the tank, but not allow methanol vapors to release. This is simply my experience from using this tank for a couple of years.

Yeah it's going to work well for me. I just wanted to test everything to satisfy the inquiring mind . I did notice though, the tighter you close the lid, the less vent There are which means its harder for the pump to pull meth out of it. Just a FYI. I would probably just tighten it so no liquid can spill out as it'll never tip over, but enough for the meth to flow freely.

[Former_Boosted_IS]

Originally Posted by Sloppy

Yeah it's going to work well for me. I just wanted to test everything to satisfy the inquiring mind . I did notice though, the tighter you close the lid, the less vent There are which means its harder for the pump to pull meth out of it. Just a FYI. I would probably just tighten it so no liquid can spill out as it'll never tip over, but enough for the meth to flow freely.

Go gravity fed and you will never have a problem. I have used this for a while and it has worked very well.