[Pele96]

Hey guys got a question. On my way from work today after being stopped at a red light for about two minutes I take off after making a left. Went into 3rd gear at 4000 rpms and the service engine light came on. Engine power reduced. So I thought to pull over because the car was not warmed up enough so I figured that it was just the ECU stopping me from messing up the engine. Mine you I have the Procede V2 on 94% settings. Well I pull over and shut off the engine. Turn it back on and everything reset itself. No engine light.Drove home with no problem at all. I remember Shiv saying that unless the turbo's are warmed up it is not wise to push the car that hard. Also never ever had any type of limp mode or engine light come on.

Thanks

[PresaMat]

Originally Posted by Pele96

Hey guys got a question. On my way from work today after being stopped at a red light for about two minutes I take off after making a left. Went into 3rd gear at 4000 rpms and the service engine light came on. Engine power reduced. So I thought to pull over because the car was not warmed up enough so I figured that it was just the ECU stopping me from messing up the engine. Mine you I have the Procede V2 on 94% settings. Well I pull over and shut off the engine. Turn it back on and everything reset itself. No engine light.Drove home with no problem at all. I remember Shiv saying that unless the turbo's are warmed up it is not wise to push the car that hard. Also never ever had any type of limp mode or engine light come on.

Thanks

What map are you running? Also did you recently fill up?

Mat

[Pele96]

Hi I had a 1/4 tank of tank left. Running the V 2.02 map from 12-26.

Thanks

[Pele96]

By the way flahed yellow which means overload..

[2007_E93]

Originally Posted by Pele96

By the way flahed yellow which means overload..

I had a similar issue after a WOT run the first few days after installing 2-26 map. I ran WOT then stopped to end the datalog and while parked it gave me the SES light and stalled. Never happened since. No codes in the OBDII when I checked. I just keep an eye on it for now. I guess the car had to adapt a bit more,...

[Pele96]

Really. Well I have been running this map since Jan 08 with no problems. I need to datalog some more though..

[Pele96]

Well I decided to download the new V2.02 2-26-08 file. So far so good. No problems. I will do some datalogs and then raise the torque settings from 90% on up.