[carbonSI]

Done a search but can't find anyone with similar problem

Got a 56 plate 320si, just had non run flats fitted. Followed the manual to reset the tyre pressure warning system, after holding BC for more than five seconds a box with a tick is supposed to appear but nothing happens on mine?? All it does is take away the small arrow next to the word init...

[turboblue]

Recently had to reset the monitor myself - and the process does not seem to be entirely obvious.

You need to select the tyre-reset option and then press the BC button to select it.

Press the BC button again and you should get the little tick appear in the box.

Then - press and HOLD the BC button for about 5 seconds or so, after which you should get a bleep and a re-set message.

Took me several goes to realise you need to select the tick box first...

[HighlandPete]

Once you select the tyre reset function, you then press and hold the button until the tick appears. That's how mine works. Drive off and it re-calibrates the system.

HighlandPete

[carbonSI]

Thanks chaps il give it a go and report back tmrw

[carbonSI]

Originally Posted by turboblue

Recently had to reset the monitor myself - and the process does not seem to be entirely obvious.

You need to select the tyre-reset option and then press the BC button to select it.

Press the BC button again and you should get the little tick appear in the box.

Then - press and HOLD the BC button for about 5 seconds or so, after which you should get a bleep and a re-set message.

Took me several goes to realise you need to select the tick box first...

Thnx Turboblue that did the trick!!