|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Heat soak questions
|
|
03-05-2010, 09:05 AM | #1 |
Major
79
Rep 1,032
Posts |
Heat soak questions
OK, I saw some folks with Turbo Silvia, Supra, etc spray those air can dusters onto their intercoolers to minimize heat soak. They claim it works perfectly on their OEM intercoolers. What do you think, folks?
I am talking about this air can duster: http://www.factorydirect.ca/catalog/...p?pcode=ME8038 |
03-05-2010, 09:11 AM | #2 | |
441
Rep 18,331
Posts |
Quote:
Not worth the money, go out and get an upgrade FMIC if your worried about heatsoak! |
|
Appreciate
0
|
03-05-2010, 12:52 PM | #3 | |
Major
79
Rep 1,032
Posts |
Well, how much will that small fire extinguisher cost?
Normally, upgrade FMIC = at least $900. Quote:
|
|
Appreciate
0
|
03-05-2010, 01:07 PM | #4 |
Major General
2045
Rep 6,109
Posts |
What mods do you have on your car currently? An upgraded FMIC might not be a bad idea if you are at the level where your car could consistently benefit from it.
__________________
When you say impact instead of affect/effect, you are communicating that you don't understand the difference between the two words, and are too lazy to learn.
|
Appreciate
0
|
03-05-2010, 01:31 PM | #6 | |
Major General
161
Rep 7,377
Posts |
Quote:
__________________
07 335i AT - MOTIV 750 - MHD E85 BMS flash - BMS PI - JB4G5 - Okada Coils - NGK 5992 Plugs - Helix IC - Snow Stg. 3 - Stett CP - Custom midpipes with 100 HJS Cats - Bastuck Quad - PSS10 - QUAIFE LSD - BMS OCC - Forge DVs - AR OC - ALCON BBK - M3 Chassi - Dinan CP - Velocity M rear Toe arms - Advan RZ-DF - LUX H8 - Level 10 AT upgrade
|
|
Appreciate
0
|
03-05-2010, 07:14 PM | #8 |
Lieutenant General
178
Rep 11,768
Posts |
or in lamen's terms, heatsoak=slower and slower car as the engine pulls timing, upgraded fmic=consistent power.
__________________
-Rev
SGM e92 335xi|Helix|AFE|AWE|PROCEDE|SYNAPSE|ER|OSS|BMW PERFORMANCE|P3|always growing.. |
Appreciate
0
|
Bookmarks |
|
|