|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Not hitting target boost levels on single turbo N54
|
|
07-28-2023, 05:42 PM | #1 |
New Member
8
Rep 12
Posts |
Not hitting target boost levels on single turbo N54
Hi all. I am having issues with my single turbo setup not hitting target boost. I am on map 2 which should be 17 psi but I am only getting 11 because of my wastegate springs (11 psi)
I did boost leak test and I did have a lot of leak because i changed my 4 O2 senors trying to fix fuel trim issues so took a lot of things off and put them back together. However after installing 4 new O2 sensors in realized that my valve cover had hair line crack in it so that is what caused my fuel trims variations . So I changed my valve cover as well . Fixed all boost leaks and pressurized system to 20 psi all good there. I am still not hitting boost target. I have JB4 that controls my boost and according to JB4 I can test mac solenoid by having car in any map , ignition on and by pressing gas pedal. I should be hearing clicks from Mac solenoid but I am not hearing anything at all. I unplugged mac solenoid and applied 12 volts from motorcycle battery and solenoid is clicking . I tested wire harness where 2 oem boost solenoid used to connect and I am getting 12 v on wire 1 and 0 volts on wire 2 . Same story with the other boost solenoid wire that is in the harness. To my understanding I should be getting 12v on wire 1 and 6 volts on wire 2. So I am at the loss why I am getting 0 v on wire 2 . I also checked all fused in glove compartment and they are all good. Any one might know what might be the issue? Update: Changed my Mac solenoid few days ago still same issue. Mac solenoid will not click when Ignition is on , map 1 and pressing gas pedal . I tried different maps still same boost 11 psi Anyone know what this might be ? http://www.datazap.me/u/kaldyn55/3rd...log=0&data=1-4 |
Bookmarks |
|
|