|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Number plate LED bulbs
|
|
06-27-2016, 06:34 AM | #1 |
Private First Class
10
Rep 140
Posts |
Number plate LED bulbs
Hi all,
I have replaced my number plate bulbs with CANBUS - Error Free - 6LED bulbs from eBay which have been fine. However, the right side bulb keeps turning upside down inside the housing when the boot is opened/closed. Any ideas how to get it to stay put on a 2007 E92? Also, can these bulbs cause any issues with the electrics? I know modern BMWs require careful electrical maintenance and all. I would also like to replace all interior bulbs with LEDs. Any recommended sellers I can go to? Thank you, |
06-27-2016, 07:04 AM | #2 |
First Lieutenant
50
Rep 302
Posts |
I'm sure you can just bend the contact terminals a tad to made it a firmer hold. I had this issue when I replaced some of my bulbs to LED.
|
Appreciate
0
|
06-27-2016, 08:50 AM | #3 |
Private First Class
24
Rep 189
Posts |
I had the exact same problem. Solution was to buy slightly bigger ones so they fit more snug. I tried the above but it eventually worked free again.
Forgotten what MM They were but I think I went from 36/37 to 39mm. Ben |
Appreciate
0
|
06-27-2016, 12:24 PM | #4 |
Private First Class
10
Rep 140
Posts |
Just had a look and it's fallen into the trunk lid. Any ideas on how to get it out of there? I'm slightly OCD with my car so if there is a way I'd like to take a look
EDIT: I managed to prise the trim on the inside of the boot lid and it fell right to me. I slightly bent the metal on either side to give it a snug hold. Let's see if it lasts. Last edited by WonderBang; 06-27-2016 at 12:40 PM.. |
Appreciate
0
|
06-28-2016, 11:31 AM | #5 | |
First Lieutenant
28
Rep 306
Posts |
Quote:
|
|
Appreciate
0
|
Bookmarks |
|
|