|
|
|
|
PLEASE HELP SUPPORT E90POST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
TPMS install
|
|
Wheels and Tires forum Sponsored by The Tire Rack
Please help to directly support e90post by doing your tirerack shopping from the above link. For every sale made through the link, e90post gets sponsor support to keep the site alive. Disclaimer |
|
Thread Tools | Search this Thread |
03-14-2014, 05:06 PM | #1 |
BMW enthusiast
58
Rep 386
Posts |
TPMS install
Hey guys,
Question for you guys who have installed TPMS on wheels. Trying to install my new Beru TPMS on my summer Apex wheels and I've read some DIY instructions to help me out. I am using a torque wrench set to 35 and as I tighten the nut on the outside of the wheel the rubber washer on the inside gets very squished for lack of a better term before I get to the 35 torque on the wrench. Is this normal? Do I just keep going till I hit the 35? Beru instructions that I found say to tighten to torque spec which is 4/35. Scott |
Bookmarks |
|
|